www.askey.com.tw
RT360W-D56 Wireless Broadband USB AP
ASKEY
features and 1-port LAN . The 802.11g Access Point features allow PCs/Notebooks
with wireless card that adapts 802.11g technology to connect to the Ethernet. Through
the LAN connection to connect Local Area Network.
’s RT360W-D56 is 802.11g Wireless Access Point & USB Print Server
[Hardware Specifications]
Main Chip Sets
Processor: Broadcom BCM4702 125MHz R3000 MIPS32 CPU
•
54g (draft IEEE802.11g) Broadcom Radio
•
BCM4306 MAC and Baseband Processor
−
BCM2050 Radio
−
Memory
•
4MB Flash
−
16MB SDRAM
−
Interface
One 2.4GHz 54g RF interface for Wireless LAN connection
•
One 10/100 Mbps RJ-45 Ethernet LAN connection
•
Two USB 1.1 Ports for printer connection
•
Radio Characteristics
Standard: IEEE 802.11b (Wi-Fi) and 54g (draft IEEE802.11g)
•
Frequency Band (ISM Band):
•
2.412 ~ 2.4835 GHz
−
Spreading:
•
Direct Sequence Spread Spectrum (11-chip Barker sequence)
−
Modulation
•
OFDM: 54, 48, 36, 24, 18, 12, 9, and 6 Mbps
−
CCK: 11 , and 5.5 Mbps
−
DQPSK: 2 Mbps
−
DBPSK: 1 Mbps
−
Number of Channels:
•
802.11b : 1 - 11 (FCC), 1 - 13 (Europe ETSI), 1 – 14 (Japan)
−
June. 30, 2003
- 1 -
Rev: 0.0
•
54g : 1 - 11 (FCC), 1 - 13 (Europe ETSI), 1 – 14 (Japan)
−
Data Rate:
54g
−
54 Mbps
48 Mbps
36 Mbps
24 Mbps
18 Mbps
12 Mbps
9 Mbps
6 Mbps
802.11b
−
11 Mbps
5.5 Mbps
2 Mbps
www.askey.com.tw
1 Mbps
Antenna:
•
One external antenna
−
RF Output Power:
•
15 dBm (typical)
−
Range:
•
54 Mbps range in a typical office environment of up to 30 m and line-of-sight
−
(LOS) up to 150 m
11 Mbps range in a typical office environment of up to 60 m and line-of-sight (LOS)
−
up to 300 m
1 Mbps range in a typical office environment of up to 120 m and LOS up to 650 m
−
Range differs by environment
−
Power Consumption:
•
TX: TDB mA
−
RX: TDB mA
−
Receiver Sensitivity: Per <8% @ length 1024 octets
•
54 Mbps: TDB dBm
−
11 Mbps: -80 dBm
−
5.5 Mbps: -88 dBm
−
2 Mbps: -91 dBm
−
1 Mbps: -93 dBm
−
WEP Hardware Engine
•
64 Bits
−
June. 30, 2003
- 2 -
Rev: 0.0
128 Bits
−
Power and Operation Environment
Power Input:
•
5 Volts DC, 2 A
−
Temperature
•
Operating: 0°C to 40°C
−
Storage: -10°C to 65°C
−
Humidity:
•
5% to 80% (non-condensing)
−
LED Indicators
POWER
•
WLAN (two color)
•
WAN (two color)
•
HOST
•
www.askey.com.tw
ERROR
•
Physical
•
PCB Dimensions: 100 mm (L) × 90 mm (W)
[Software Specifications]
- Web Management Interface
- 11G wireless capability
- LPR/LPD protocol
This standard LPR/LPD support makes the print server easily work with all different
•
Windows OSs and almost all different variations of Unix.
- Internet Printing Protocol (IPP/1.1)
IPP is a relatively newer printing protocol; it gets widely supported recently. Microsoft has
•
built-in IPP support on Windows 2000/XP.
- Support Netbeui (Samba/Windows)
This will enable a printer device showing up on Windows machine networking
•
neighborhood. By double-clicking the printer icon, windows guides user through the
process of installing the driver for the printer.
- AppleTalk (Mac)
To work with MAC running AppleTalk protocol. Only support postscript printers.
•
- Unix Text File Support
Can configure automatically to convert LF to CR+LF
•
June. 30, 2003
- 3 -
Rev: 0.0
www.askey.com.tw
- IP Finder utility
Find the IP address of print server and then link to print server's web management page.
•
- Test button
A SW printing test button in print server's web management page.
•
June. 30, 2003
- 4 -
Rev: 0.0
WARNING TEXT
Radio Frequency Interference Requirements
This device is restricted to INDOOR USE due to its operation in the 5.15 to 5.25GHz frequency
range. According to FCC 15.407(e), requires this product to be used indoors for the frequency
range 5.15 to 5.25GHz to reduce the potential for harmful interference to co-channel of the
Mobile Satellite Systems.
High power radars are allocated as primary user of the 5.25 to 5.35GHz and 5.65 to 5.85GHz
bands. These radar stations can cause interference with and / or damage this device
802.11b Restrictions:
- European standards dictate maximum radiated transmit power of 100mW EIRP
and frequency range 2.400-2.4835GHz;
- In France, the equipment must be restricted to the 2.4465-2.4835GHz
frequency range and must be restricted to indoor use."
15.105 Federal Communications Commission (FCC) Requirements, Part 15
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide rea sonabl e protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encou raged to try to
correct the interference by one or more of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
---Consult the dealer or an experienced radio/TV technician for help.
Regulatory information / Disclaimers
Installation and use of this Wireless LAN device must be in strict accordance with the instructions
included in the user documentation provided with the product. Any changes or modifications
(including the antennas) made to this device that are not expressly approved by t he manufacturer
may void the user’s authority to operate the equipment. The manufacturer is not responsible for
any radio or television interference caused by unauthorized modification of this device, or the
substitution of the connecting cables and equipment other than manufacturer specified. It is the
responsibility of the user to correct any interference caused by such unauthorized modification,
substitution or attachment. Manufacturer and its authorized resellers or distributors will assume
no liability for any damage or violation of government regulations arising from failing to comply
with these guidelines.
MPE Statement (Safety Information)
Your device contains a low power transmitter. When device is transmitted it sends out Radio
Frequency (RF) signal.
Safety Information
In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be
installed and operated with minimum distance 20cm between the radiator and your body. Use
only with supplied antenna. Unauthorized antenna, modification, or attachments could damage
the transmitter and may violate FCC regulations.
Loading...