Page 1
MOUNTING INSTRUCTION
ZIP Economizer™ Communication Module
71525-00001_A
Installation
Each ZIP Economizer module is designed with a unique form fit which allows it
to fit only in one location on the ECON-ZIP-BASE.
Insert the ECON-ZIP-COM module in the far right (designated) slot of the ZIP
Economizer base unit. Illustration located below for location.
Removal of ECON-ZIP-COM
Insert a flat head screw driver into the latch of the module. Apply light
pressure on the latch away from the base unit. Lift up to remove.
Press firmly to lock the module in place – you will hear a snap.
10/12 - Subject to change. © Belimo Aircontrols (USA), Inc.
ECON-ZIP-COM
Technical Data
Type Name Description Electrical Specification
RS485 Interface
Optical Isolation max. 1k VDC
(for max. 1min)
Pin 4: RS485 Com Gnd
Pin 7: RS485 Com A
Pin 8: RS485 Com B
Relay contact 24 V
Normal current: 0.5A
Inrush current: 1A
I/O Comm
Relay ALM
Comunication
interface
Diagnostic
alarm
1
Page 2
Wiring Diagram
MOUNTING INSTRUCTION
ZIP Economizer™ Communication Module
2
10/12 - Subject to change. © Belimo Aircontrols (USA), Inc.
Loading...