Beko TZDA 568 FW, TZDA 568 FS User Manual

6.9 cu.ft. Frost Free Tall Freezer

TZDA 568 FW TZDA 568 FS

BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 0845 6004911 Fax: 0845 6004922 e-mail: service@beko.co.uk website: www.beko.co.uk

Printed in Turkey

Part no: 48 6215 00 01

Congratulations on your choice of a quality Appliance which has been designed to give you service for many years.

WARNING ! IMPORTANT !

DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed.

• Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally.

• If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children.

• This freezer must only be used for its intended purpose i.e. the storing and freezing of edible foodstuff.

• Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an ongoing commitment. This appliance which is among the latest range introduced is particularly environment friendly. Your appliance contains non CFC / HFC natural substances in the cooling system (Called R600a) and in the insulation(Called cyclopentane) which are potentially flammable if exposed to fire. Therefore, take care not to damage, the cooling circuit / pipes of the appliance in transportation and in use. In case of a damage do not expose the appliance to fire, potential ignition source and immediately ventilate the room where the appliance is situated.

• We suggest you contact your local authority for disposal information and facilities available.

• To obtain the best possible performance and trouble free operation from your appliance it is very important to carefully read these instructions.

• On delivery, check to make sure that the product is not damaged and that all the parts and accessories are in perfect condition.

• Ensure that the plug remains readily accessible. Do not use multiple adapter bar or extension cable.

• Failure to observe these instructions may invalidate your right to free service during the guarantee period.

• This appliance is suitable for use in out-buildings subject to conditions. Please see Installation Instructions and other requirements contained in this booklet.

WARNING- Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

WARNING- Do not damage the refrigerant circuit. WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,

unless they are of the type recommended by the manufacturer.

• We suggest you keep these instructions in a safe place for easy reference.

Frost Free Tall Freezer

TZDA568F

PERFORMANCE

Energy efficiency class Energy consumption - Kwh/year

Net storage - vol fresh food ltrs (cu.ft.) Net storage - vol frozen food ltrs (cu.ft)

Total net vol - ltrs (cu.ft.) Frozen food compartment rating

Conservation time from failure

Freezing capacity fresh food - kg (lb) /24 hrs.

Climate class Operating noise level dB(A)

288

----196 (6.9) 196 (6.9)

4 STAR

15 hrs.

10 (22)

CONTENTS PAGE

SAFETY FIRST / ELECTRICAL REQUIREMENTS

TRANSPORTATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

STARTING

TEMPERATURE CONTROL AND ADJUSTMENT

STORING FROZEN FOOD

FREEZING FRESH FOOD

MAKING ICE CUBES

DEFROSTING

CLEANING AND CARE

DO'S AND DON'TS

PROBLEM SOLVING/ TROUBLE SHOOTING

REVERSING THE DOOR

GUARANTEE DETAILS

13 15

HOW TO OBTAIN SERVICE

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your

electricity supply. Rating label is on the left hand side of the freezer liner. We recommend that this appliance is connected to the mains supply via a

suitable switched and fused socket. The socket must be in an accessible position. Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead

which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a

plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers can be obtained from a BEKO authorised service

agent.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the mains lead of this appliance may

not correspond with the coloured markings identifying the terminals

in your plug proceed as follows:

32mm.

BROWN

22mm.

6mm.

CORD GRIP

6mm.

RED

6mm.

FUSE

12mm.

FITTED WITH

FIT BS 1362 REPLACEMENT

BS 1362 13A FUSE ALWAYS

(See diagram).

1. Connect the green-yellow or green (Earth) wire to the terminal

in the plug marked 'E' or with

the symbol or coloured

green and yellow or green.

2. Connect the blue (Neutral) wire

GREEN & YELLOW

GREEN

BLUE

BLACK

to the terminal in the plug marked 'N' or coloured black.

CARTRIDGE FUSE

3. Connect the brown (Live) wire to the terminal in the plug marked 'L'

or coloured red. With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or

in the main fuse box. If in doubt contact a qualified electrician.

TRANSPORTATION INSTRUCTIONS

1. The freezer should be transported only in a vertical upright position.

The packing as supplied must be intact during transportation.

2. If during the course of transport the appliance has to be transported horizontally,

the product must only be laid on its right hand side (when facing the door front) and it must not be operated for at least 4 hours to allow the system to settle after the appliance is brought back to upright position.

3. Failure to comply with the above instructions could result in damage occuring

to the freezer. The manufacturer will not be held responsible if these instructions are disregarded.

4. The freezer must be protected against rain, moisture and other atmospheric

influences.

5. When positioning your appliance take care not to damage your flooring,

pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal support or pipework at the back of the appliance as you might injure your fingers and hands or damage your product.

IMPORTANT : This appliance is not designed for stacking with any other appliance.

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

IMPORTANT : Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged.

Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.

CAUTION

If you try to reopen the door soon after closing it you will notice that it can require a lot more force than usual and this may cause the product to tilt towards you if pulled excessively, care should be taken if reopening.

This is caused by warm air entering as the door opens. After the door is closed the warm air cools rapidly causing a partial vacuum which makes it difficult to reopen the door. If you wait a moment or two the pressure soon equalises and the door will be easy to open again.

If you would prefer, we can supply free of charge a side fitting handle that because of it ‘s more central location will make reopening easier under the circumstances described above.

INSTRUCTIONS TO OBTAIN & FIT THE OPTIONAL SIDE FITTING HANDLE:

To fit the handle, simply remove the two plastic plugs on the side you want to fit the handle to, fit the handle using the two screws supplied and fit the screw caps supplied to cover the screws.

+ 11 hidden pages