DE 2541 F
* Values declared on the product or in the operating instruction booklet / programme chart and quick
reference card supplied with the product are obtained in tests performed under controlled laboratory conditions
and these tests are as defined in relevant standards.
These figures may vary depending on how soiled the dishes
are, the water hardness level and other factors. Temperature changes exceeding 15°C may also effect these
figures.
** Reference programme for the Testing Institute and energy labelling. Testing program: Eco 50°C as compliant
to EN 50242 international norms.
*** Due to continual improvement through research & design, specifications and design may change without
prior notice.
DE 2541 F Programme Chart and Quick Reference Guide
Before starting, it is essential that you carefully read right through the Installation
& Operation Instruction booklet before plugging in to the mains socket.
Printed in Turkey Part no: 17 2197 01 00-02
Beko plc, Beko House, Caxton Way, Watford, Hertfordshire, WD18 8UF
Tel : 01923 654650 Fax : 01923 819653 e-mail: service@beko.co.uk www .beko.co.uk
Detergent
compartment
A=25 cm³ /
15 cm³
B=5 cm³
Programme
sequence
Consumption
figures
Water (Litres)
Energy (kWh)
Duration (min)
Programme
symbols and
temperatures
Programme
selection
14,4
1,30
115
70 °C wash
Cold rinse
50 °C rinse
50°C Prewash
A+B
Drying
5
INTENSIVE
70°C
Heavily soiled
dishes
requiring Hot
pre-wash
A+B
10,6
1,15
58
QUICK & CLEAN
60°C
4
Soiled dishes
60 °C wash
Cold rinse
Hot rinse
Drying
A+B
13
1,01
140
3
ECONOMY
50°C
50 °C wash
Cold rinse
Hot rinse
Drying
Prewash
Most
economic
programme
for normally
soiled dishes
A
35 °C wash
Cold rinse
Hot rinse
End
10,2
0,75
30
2
RAPID
35°C
Lightly soiled
dishes
30 minute
programme
-
3,6
-
15
Pre-wash to
rinse and
loosen residue
- awaiting full
load - then
select a
Programme
1
PRE-WASH
No Heat
End
Prewash
Start/Stop Button
Start / Stop
End
indicator lights
Progress
Wash
On/Off
indicator light
indicator light
Rinse Aid
Rinse-aid
Salt indicator light
On / Off Button
Salt
On / Off
carried out by the previous programme selection.
· Press start/stop button. The wash indicator light will go off.
How to change the washing programme
To change the programme selection while the machine is operating:
· Select the new programme. Press start/stop button. The wash indicator light will be on and
new programme will start.
! The new programme will NOT start right from the beginning. It will start from the stage last
! Depending on the stage of the programme you have cancelled, there may be detergent
residue or rinse aid inside the machine and on the load. Make sure the items in the dishwasher
are not used before washing properly.
The machine will drain the water inside the machine for 45 seconds.
· The programme is cancelled when wash indicator light goes off. Then, you can choose and
start a new programme.
· Press and hold start/stop button for 3 seconds. The wash indicator light will start flashing.
on.
selected is completed, "Wash" indicator light will go off and "End" indicator light will come
How to cancel the washing programme
To cancel a programme while the machine is operating:
Programme Sequence
While the dishwasher operates, "Wash" indicator light will be on. When the programme
· Turn off the water tap, unload the baskets.
door is opened while the machine is working, then a safety mechanism ensures the machine
immediately stops. Water may be very hot, so be careful.
!
· Press the on/off button after the programme is completed. The indicator light will go off.
Care must be taken if opening the door, as steam and water will escape.
add salt and rinse aid.
· Check the salt and rinse aid level indicator lights before you start the machine. If necessary
· Select the required programme by referring to the programme chart.
· Select the desired programme by turning the selector knob.
· Press start / stop button and check that the wash indicator light comes on.
! Do not open the dishwasher door whilst the appliance is in operation. However, in case the
· Close the door of the machine.
· Push in the on/off button and check that the on/off indicator light comes on.
· Check that the upper and lower arms can rotate freely.
· Pour (Put in) the detergent.
Operating the dishwasher
·
Turn the water tap on. Open the door of the machine.
2
Start / Stop
1
Rinse Aid
5
4
3
End End
Salt
Wash
End
PRE-WASH
No Heat
RAPID
35°C
ECONOMY
50°C
QUICK & CLEAN
60°C
INTENSIVE
70°C
1
2
3
4
5
End
On / Off
Loading...