BCS Speed Dome 66 Installation Manual

Speed Dome 66 Installation Manual

2

Table of Contents

1 INSTALLATION...................................................................................................6

1.1 Installation Preparation .........................................................................................................................6

1.2 Installation Mode....................................................................................................................................6

1.2.1 Speed Dome Installation Mode.......................................................................................................6

1.2.2 Bracket Installation Mode................................................................................................................7

2 SPEED DOME INSTALLATION.......................................................................... 9

2.1 General Introduction..............................................................................................................................9

2.2 Hanging Bracket Speed Dome Installation........................................................................................9

2.2.1 Installation Requirement..................................................................................................................9

2.2.2 Hanging Bracket Installation ...........................................................................................................9

2.2.3 Camera Installation.........................................................................................................................11

2.3 Corner Bracket Speed Dome Installation.........................................................................................13

2.3.1 Installation Requirement................................................................................................................13

2.3.2 Corner Bracket and Hanging Bracket Installation......................................................................13

2.4 Pole Bracket Speed Dome Installation.............................................................................................15

2.4.1 Installation Requirement................................................................................................................15

2.4.2 Pole Bracket Installation................................................................................................................16

2.5 Suspended Bracket Speed Dome Installation.................................................................................17

2.5.1 Installation Requirement................................................................................................................17

2.5.2 Accessories Installation.................................................................................................................17

3

Welcome

Thank you for purchasing our speed dome!

Please read the following safeguards and warnings carefully before you install
or use the product!

4

Important Safeguards and Warnings
Safety Measures

Qualified Engineer Needed

z The installation engineer or maintenance engineer shall have corresponding

CCTV system installation certificate or maintenance qualification certificate.

z The installation engineer or maintenance engineer shall have qualification

certificate for work at height.

z The installation engineer or maintenance engineer shall have the basic

knowledge and operation technique for low-voltage cable layout and low-voltage
electronic cable connection.

z Please read the installation manual carefully and keep it well for future reference,
z We are not liable for any problems caused by unauthorized modifications or

attempted repair.

Lifting Appliance Requirement

z Please select the proper speed dome installation mode and use the lifting

appliances at the safety environment.

z The lifting appliances shall have the enough capacity to reach the installation

height.

z The lifting appliances shall have safe performance.

Precautions

Safety Transportation

z Heavy stress, violent vibration or water splash are not allowed during

transportation, storage and installation.

z This series product must use split type package during the transportation.
z We are not liable for any damage or problem result from the integrated package

during the transportation.

When device is malfunction

Shut down the device and disconnect the power cable immediately if there is smoke,
abnormal smell or abnormal function. Please contact your local retailer ASAP.

5

Do not try to dismantle or modify the device

z There is risk of personal injury or device damage resulting from opening the shell.
z Please contact your local retailer if there is internal setup or maintenance

requirement.

z We are not liable for any problems caused by unauthorized modifications or

attempted repair.

Do not allow other object falling into the device

z Please make sure there is no metal or inflammable, explosive substance in the

speed dome.

z The above mentioned objects in the device may result in fire, short-circuit or

damage.

z Please shut down the device and disconnect the power cable if there is water or

liquid falling into the camera. Please contact your local retailer ASAP.

z Please pay attention to the camera. Avoid the sea water or rain to erode the

camera.

Handle carefully

Do not allow this series product fall down to the ground.
Avoid heavy vibration.

Installation Environment Requirement

z This series speed dome should be installed in a cool, dry place away from direct

sunlight, inflammable, explosive substances and etc.

z This series product shall be away from the strong electromagnetism radiant,

please keep it away from wireless power, TV transmitter, transformer and etc.

Daily Maintenance

z Please use the soft cloth to clean dust on the shell, or you can use soft cloth with

cleaning liquid to clean the shell and then use soft cloth to make it dry.

z Do not use gasoline, dope thinner or other chemical material to clean the shell. It

may result in shell transfiguration or paint flake.

z Do not allow the plastic or rubber material to touch the shell for a long time. It

may result in paint flake.

6

1 INSTALLATION

1.1 Installation Preparation

Basic Requirement

z All installation and operation here should conform to your local electrical safety

codes.

z Before installation, please open the package and check all the components are

included. Please make sure the speed dome installation environment and
installation mode can meet your requirement. If there is special requirement,
please contact your local retailer for more information.

z We assume no liability or responsibility for all the fires or electrical shock caused

by improper handling or installation.

Check installation space and installation location intension

Please make sure the installation environment has enough space to install the speed
dome and its corresponding bracket.
Please make sure the ceiling, wall, bracket can support the speed dome and its
corresponding installation component. The safety factor shall be 4X.

About cable

Please select the cable according to your transmission distance.
The minimum video coaxial-cable requirement is:

z 75 ohm.
z Full cable with copper conductor
z 95% knitted copper shield

International Model Max Distance

(Ft\M)

RG59/U 750ft (229m)
RG6/U 1,000ft (305m)
RG11/U 1,500ft (457m)

Set dial switch button

Set dial switch button according to control protocol and speed dome address.
(Please refer to user’s manual for detailed information.)

Please keep all package material well for future use

Please keep speed dome package material well in case you need to send it back to
your local retailer or manufacturer for maintenance work.
Non-original package material may result in device damage during the transportation.

1.2 Installation Mode

1.2.1 Speed Dome Installation Mode

The integrated speed dome has the following installation modes:

z Embedded installation
z In-ceiling installation
z Bracket installation

1.2.2 Bracket Installation Mode

The bracket installation consists of the following modes:

z Hanging installation
z Corner installation
z Pole installation
z Suspended installation

The bracket installation is suitable for indoor and outdoor environment. The outdoor
speed dome has a sun-shade cover and it also has an internal heater device.
The outdoor speed dome IP standard is IP 66.

1.2.2.1 Hanging Installation
This series installation mode is suitable for indoor and outdoor hard wall structure.
See Figure 1-1. Please refer to chapter 2.2 for detailed information.

Figure 1-1

1.2.2.2 Corner Installation
The corner installation is suitable for indoor and outdoor hard wall structure

environment where the angel is 90 degrees. See

Figure 1-2. Please refer to chapter

2.3 for detailed information.

7

Figure 1-2

1.2.2.3 Pole Installation
Pole installation is suitable for indoor and outdoor hard pole structure. See Figure

1-3. Please refer to chapter 2.4 for detailed information.

8

Figure 1-3

1.2.2.4 Suspended Installation
The suspended installation has the following two types. Please refer to chapter 2.5

for detailed information. See Figure 1-4.

With Pole

Without Pole

Figure 1-4