BBK Performance 1698 User Manual

INS166

2005-2010 FORD MUSTANG
X-PIPES FOR FULL LENGTHS
PART# 1636/5,1637/5,16995,16985

TOOLS REQUIRED-13, 15mm sockets, ratchet, ¾” wrench, 22mm wrench.

STEP 1
STEP 2
STEP 3
STEP 4

STEP 5
STEP 6
STEP 7
STEP 8

STEP 9

Disconnect negative battery cable.
With BBK Full Length headers (part #’s 1641/0/5 or 16495 ) installed, lift X-pipe in place.
Line up rear of X-pipe with stock barrel style clamps and slip clamps over reduced end of X-pipe.
Position X-pipe collector flanges up to headers, connect headers and X-pipe with studs supplied
in the header kit.
Adjust position of exhaust system for fitment and clearance. Tighten clamps and collector nu t s.
Remove rear O2 sensors from the stock midpipes.
Install rear O2 sensors in the BBK X-pipe.
Connect supplied O2 sensor extension wires to plugs at wire harness at the side of the trans.
Connect the sensors.
Start engine and check for any exhaust leaks.

X-pipe shown installed

Connects to stock rear barrel-style clamps

IMPORTANT- All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.