BBK Phenolic Spacer Kits
Special Tools
Install Time:
Difficulty:
STEP 3
STEP 2
STEP 7
STEP 5
STEP 8
bolts.
Part # 1506,1508,1520,1530,1549
Required:
No special tools
•
required
Follow these instructions carefully to ensure correct fitment and operation.
STEP 1
• Disconnect the throttle duct hose from the
throttle body.
• Disconnect the throttle linkage from the throttle
body and also the kick-down linkage if
applicable.
• Disconnect the wire connectors from the upper
manifold and also the vacuum lines on the
underside of the upper intake.
STEP 4
STEP 6
• Next install the phenolic spacer by placing a
new gasket on both sides of the spacer.
• Use the new bolts provided and tighten in a
criss-cross pattern beginning with the center
• Next simply reverse the previous steps.
Approximately
1 Hour
3 out of 5
• Remove the cover plate from the upper intake if
• Lift off the upper intake and discard the gasket,
equipped. Next remove the six bolts from the
upper intake manifold.
also making sure both surfaces are free from
dirt and grease.
1
INS-003
Loading...