BBK Performance 1025 User Manual

‘05 & Up V-8 Mustang Intake Cover
Part #’s 1025-10250

INS-100

INSTALLATION INSTRUCTIONS

www.BBKPERFORMANCE.com

IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).

!CAUTION!

ALWAYS USE PROTECTIVE EYEWEAR

Included in this kit: Intake cover, and mounting bolts.

Tools required: 1/4" ratchet, 8mm socket, and 5mm Allen wrench.

Step 1 Pull the wiring harness locating tabs off of the 4 fuel rail mounting bolts.

Step 2 Remove the 4 fuel rail mounting bolts.

Step 3 Place the BBK intake cover over the intake manifold by tipping the front up slightly to allow the rear to clear the

firewall while guiding the cover into position.

Step 4 Tuck the wiring harness locating tabs between the intake cover and fuel rails and tighten the supplied bolts in

place of the original hardware.

Please visit us at www.BBKPERFORMANCE.com to view a fully photographed installation of this and the many
other BBK products available to help maximize the performance potential of your vehicle.