BBE DI-10 User Manual

BBE DI-10
USER MANUAL

▲

Congratulations on the purchase of your
BBE DI-10 direct box!

The BBE DI-10 is an active direct box used for converting line out and
speaker out signals to balanced and unbalanced signals. The user also
has the ability to select between two frequency responses (flat, or
speaker compensated). Using the outputs from the DI-10, the user can
direct feed to a mixer, recorder, or sound reinforcement system.

The features that make up the BBE DI-10 are:

1. Speaker thru and Speaker input jacks.

2. 1/4” phone jack for line level signal input and output.

3. XLR jack for mic level, balanced output.

4. Filter switch to operate the speaker simulating filter.

5. Tri-mode powering for three different modes of powering:
a) internal 9V battery,
b) 9VDC external power source, and
c) 48V phantom power source through the XLR connector.

6. Tri-mode power scanning feature which scans the three power

sources and uses only the highest source of power and shuts off the
other power sources.

IMPORTANT

Before you begin, please check the contents within this box to insure
that included are:

1. The BBE DI-10.

2. Four (4) Rubber Feet for table-mount application.

3. The BBE DI-10 user’s manual.

4. 9VDC External Power Source.

Use the following illustrations as a starting point for proper placement
of the BBE DI-10.

i - BBE DI-10 INSTALLATION INSTRUCTIONS

LINE OUT

LINE IN

BALANCED OUTPUT

SPEAKER OUT

SPEAKER THRU

SPEAKER IN

BALANCED OUTPUT

DI-10

MIXING CONSOLE

PA SPEAKER

PA SPEAKER

AMP & SPEAKERS

DI-10

MIXING CONSOLE

PA SPEAKER

PA SPEAKER

AMP & SPEAKERS