Baumer HS35 User Manual

Installation instruction protective cover HS35

Features

Protective cover for encoder HS35 – matched for motor flange NEMA 56C (4,5“) and fan cover.
For attachment to a fan cover hammer head bolts are recommended (not included).

Scope of delivery

- 1x protective cover HS35

- 1x contact protection clip

- 3x cylinder screw (0.75 inch long)

- 3x flat washer

- 3x lock washer

- 1x protective label

02.12 – SAP-No.:11085289

Subject to modification in technic and design.

www.baumer.com Errors and omissions excepted.

Mounting protective cover HS35

• The incremental encoder must be slide on to
driveshaft by hand. Do not force! If necessary check

screw customer-supplied

and verify the driveshaft diameter.

• The torque support on mounting side (e.g. motor B­shield) shown in graphic [1] fastening without
pressure. Tightening torque max. 1700 oz-in (max.
12 Nm).

• The incremental encoder shaft fastening with the
clamping ring on the motor shaft. Tightening torque
of the clamping ring screw max. 312 oz-in (2.2 Nm).

[1]

• Protective cover according to graphics [2] put on the
mounting side and attach with the supplied
accessories (3x cylinder screw (0.75 inch long) with
flat washer and lock washer).
Tightening torque max. 2690 oz-in (max. 19 Nm).

[2]

• Set the contact protection clip into the opening
of the protective cover (connector/cable gland)
(graphics [3]).

[3]

opening for
contact protection
clip

contact protection
clip

• Protection label glue centred on the opening
of the protective cover (graphics [4]).

[4]

Installation instruction protective cover HS35.doc 2/2 www.baumer.com/motion
2012-02-21/rnik