Bauknecht GSI 6598 SW, GSI 6598 IN Quick Reference Guide
5019 496 90326
GB
GSI 6598
Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Time and failure display
3)
Indicates in hours the time remaining until
the start of the wash cycle. Switches off at
programme start and indicates the
remaining time in hours and minutes.
“F....” Information for the After-Sales
Service
“Delayed start” buttons
The wash cycle can be programmed to start
after 1 - 24 hours. With each successive touch
of the button, the delayed start indicator
increases by 1 hour, and after 24 returns to
00. Then press the Start button. The
dishwasher will start at the set time.
“Half load” button
This function can be used with any
programme. The indicator lamp switches on.
The wash cycle is activated for the upper
or
lower rack
only
.
When washing without the top rack, press
the “Half Load” button (LED alight).
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Programme selector knob
On / Off button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Wash cycle
Pre-Rinse Washing Drying
Programme
end
Options
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B
Litres kWh Minutes
Pre-Rinse cold
Crockery to be washed later. - - 4,0 0,03 14
Rapid 30 min 40°C
Lightly soiled crockery, with no
dried-on food.
X - 10,0 0,65 30
Standard
1)
50°C
Normally soiled crockery. X X 13,0 1,05 145
Normal 65°C
Normally or heavily soiled
crockery.
X X 13,0 1,45 100
Intensive 70°C
Heavily soiled crockery,
especially pots and pans.
X X 14,0 1,70 150
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
/ OFF button.
Large compartment
A:
With each wash cycle.
Small compartment
B:
For programmes with pre-wash only.
Mechanical indicator
C
.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator
D
.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
Only after the START button has switched off: Press the
ON /
OFF
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
How to fill the
detergent dispenser
CBA
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Select additional
options
Press the START button
“Change programme”
Press the STAR T button for 2 sec. until
the Start indicator lamp switches of f;
Select another program m e and
press the START button again.
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
Loading...