Bauknecht GSI 6586 C-IN, GSI 6586 C-SW Quick Reference Guide

GSI 6586
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Wash cycle
GB
Indicators
Programmes Loading instructions A B Litres kWh Minutes
Programme selector knob
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme.
Programme chart
Pre-wash Washing Drying
Options
“Half Load” button
This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the
or
upper
“Delayed start” button
The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time.
lower rack
Detergent
2)
only
Consumption
Programme
end
.
3)
Pre-Rinse cold
Rapid 30 min 40°C
Standard
Normal 65°C
Intensive
1) Reference programme for energy label in compliance with EN 50242 regulations;
2) Refer to “User instructions“;
1)
Crockery to be washed later. - - 4.0 0.03 14
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery. X X 13.0 1.05 110
50°C
Normally or heavily soiled crockery. X X 13.0 1.45 90
Heavily soiled crockery,
70°C
especially pots and pans.
X - 10.0 0.65 30
X X 20.0 2.00 125
3) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.
(We reserve the right to make technical modifications)
5019 496 90112
How to use the appliance
C
BA
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it).
Large compartment With each wash cycle. Small compartment For programmes with pre-wash only.
Mechanical indicator lamp C. Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator lamp D. Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Select the desired programme. The corresponding indicator lamp comes on.
A:
B:
Select additional
options
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is then memorised (even in the event of power failure).
Only after the START button has switched off: access the knob (in case of retractable knob, press and then release the knob).
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the START button for 2 sec. until the Start indicator lamp switches off;
Select another programme and press the START button again.
- Only open the dishwasher if necessary (Warning: beware of hot steam).
- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Loading...
+ 2 hidden pages