Bauknecht GSI 4754 RW-SW, GSI 4754 RW-WS, GSI 4754 RW-BR, GSI 4754 RW-IN Quick Reference Guide

GB

GSI 4754

Salt level indicator

Add regeneration salt; only add
regeneration salt immediately before
starting a wash programme.

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Option

Half Load button

This function can be used with any programme.
The indicator lamp switches on: the wash cycle
is activated for the upper or lower rack

only

.

Programme selector

Start button

Indicator lamp lit while the dishwasher is
operating.

Flashes when a fault occurs.
Switches off at the end of the programme.

Programme Symbol

and Temperature

Pre-wash

Rapid 40° C

Bio-Normal 50° C

Normal 65° C

Intensive 70° C

1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage etc.

2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

3)

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

2)

Normally or heavily soiled crockery with dried-on food.

Normally or heavily soiled crockery.

Heavily soiled pans and saucepans.

Programme selection and

recommended load type

Place the detergent in the:

small large

compartment compartment

Water

(Litres)

- - 5.0 (4.2) 0.02 (0.02) 9(9)

- X 13.0 (13.0) 0.85 (0.75) 30 (30)

X X 16.0 (14.2) 1.35 (1.28) 86 (83)

X X 16.0 (14.2) 1.55 (1.40) 86 (83)

X X 21.5 (18.2) 1.70 (1.60) 93 (90)

Consumption

Normal load / (Half load)

Energy

1)

(kWh)

5019 100 90242

(We reserve the right to make technical modifications)

Time

(Min.)

C

C

How to use the dishwasher

1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.

2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.

One of the programme indicator
lamps will switch on.

3. Turn the selector knob to select the
desired programme.

indicator lamp lights up.

select options (if supplied).

4. Press the Start button to start the
selected programme.

indicator lamp will light up.

the programmed data cannot be alte red
by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises th e
last programme selected. This
information remains in the memory even
during interruption of the power suppl y.

To change the selected
programme, press the Start button
for about 5 seconds

indicator lamp switches off.

Select a new programme using the
programme selector knob and press
the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.

5. To indicate the end of the programme,
the Start indicator lamp switches off
and

the End indicator lamp (if fitted)

switches on

The corresponding

If required,

The Start

Once set,

, until the Start

(for about 30 min.)

.

6. Turn the programme selector knob
counter clockwise to the initial position
to switch off the dishwasher (only after
the Start indicator lamp has switched
off).

All the indicator lamps switch

off.

7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.

Upper rack

Half Load:

If the upper rack
remove the cutlery basket from the lower
rack and place it in the upper one.

Rack height adjustment:

(The dishwasher is delivered with the
upper rack in the top position).

The rack height can also be changed
when loaded.

is to be loaded,

only

Upper and lower rack

• To lower: pull out the
handles and gently lower the rack.

• To raise: pull up the
until the rack clicks into place.

• The rack must be level on both
sides.

Crockery holders:

• Down: cups and long-stemmed
glasses.

• Up: plates.

side

two

side handles

two

Lower rack

Half Load:

Loading the lower rack
greater washing power, especially for
plates and saucepans.

only

gives

Cutlery basket (C):

• With or without handle (depending
on model).

• The cutlery basket can be removed
to increase available space.

Please read the user instructions carefully.

Tips and advice

• Arrange crockery so that items do not
touch each other. Arrange large
crockery in the lower rack and smaller
crockery in the upper rack.

• Load cups at an angle to facilitate
water drainage.

• Generally speaking, place cutlery in the
basket with the handles positioned
downwards, but ensure that any sharp
knives and forks that might cause
injury are placed in the basket with the
handles positioned upwards.

• Make sure the water jet can reach all
loaded items and that the spray arms
turn freely.

Important

• Fill the detergent dispenser and check
the salt and rinse aid level.

• Do no t use the appliance for items not
suitable for washing in a dishwasher,
for example: wooden items, aluminium,
plastic utensils, tin, hand-decorated
crockery (unglazed), silver cutlery.

• Do not put liquid fat in the dishwasher
(e.g. oil used for frying) or candle wax.

• If a fault occurs or you wish to change
the current programme, press the
“START” button for about 5 seconds until
the Start indicator lamp switches off.

• If regeneration salt is to be added,

immediately

in order to eliminate any residual salt
(rinsing alone is not sufficient).

• Sometimes even though the
regeneration salt container has been
filled, the corresponding indicator lamp
(if fitted) will light up during the first
wash cycle after filling with salt.

start a wash programme

• Before starting a wash programme,
make sure that the spray arms can turn
freely and are not impeded by crockery
or cutlery.

• Only switch off the dishwasher once
the “Start” indicator lamp has switched
off. If the dishwasher is switched off
during a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted without h aving
to start it again.

If a fault occurs, before contacting our
After-Sales Service, make the following
checks to try and remedy the problem:
The dishwasher is not working:

• Is the plug properly inserted in the wall
socket?

• Is there a power failure?

• Is the dishwasher switched on?

• Has the Start button been pressed?

• Has the delayed start timer been set (if

fitted)?

• Is the water supply tap on?

• Is the flow of water obstructed by

impurities? If so, close the water supply
tap, detach the water hose and clean the
filter. Then re-connect the water hose t o
the tap and open the water tap once
again.

• Are the filters clogged? (See “Care and

maintenance” chapter in the user
instructions).

• Is the door closed properly?

• Is a fault indicated?

(The Start indicator lamp flashes).
Start the programme again from the
beginning: press the Start button for
about 5 seconds, until the Start indicator
lamp switches off.

Select a new programme and press the
Start button.

Troubleshooting Guide

Crockery still dirty after washing:

• Was the crockery loaded properly?

• Crockery must be loaded facing

downwards; this is important, especially
for large items of crockery.

• The water jets must spray the entire
surface of all items.

• Make sure that crockery and cutlery are
arranged properly.

• Have you selected the correct programme?

• Did you use too much o r too little detergent?

(The use of poor quality detergents may
result in less effective washing).

• Are the filters clogged or incorrectly
assembled? (See “Care and Maintenance”
chapter in the user instructions).

• Are the spray arms blocked or the nozzles
clogged? (See “Care and Maintenance”
chapter in the user instructions).

• Is the lower spray arm correctly fitted?

• Is the salt container cap (water softening

system) screwed down?

Marked crockery:

• Is the water hardness level selector not
properly adjusted? See (“Filling the salt
container” in the user instructions).

• Is the salt container empty? (See “Filling the
salt container” in the user instructions).

• Was insufficient deterg ent used? (See
“Filling the detergent dispenser” in the

user instructions).

Marked glasses and cutlery:

• Was too much rinse aid used? (See
“Filling the rinse aid dispenser” in the user

instructions).

Note:

with some models, when the Start
button is pressed a pre-wash cycle precedes
the actual wash programme; this
regenerates the water softening system.

AFTER-SALES

SERVICE

If after carrying out the above checks
the malfunction persists or appears
again, turn the appliance off and turn
off the water supply tap, then call our
After-Sales Service (see guarantee).
Please specify:

• The nature of the fault.

• The appliance type and model.

• The service code (the number after

the word Service on the adhesive
rating plate) inside the door
on the right-hand side.

Your full address and telephone

•

number.

Please read the user instructions carefully.

Dishwasher loading instructions

LOWER RACK

UPPER RACK Half Load

Depending on the model, rack features may vary (see “Upper and lower rack” description).