Bauknecht ETPV 8640 IN User Manual

41902028GB.fm Page 81 Monday, October 11, 2010 11:04 AM

INSTRUCTION FOR USE

BEFORE USING THE GLASS CERAMIC
HOB

INSTALLATION
ELECTRICAL CONNECTIONS
ENERGY SAVING TIPS
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL

RECOMMENDATIONS
HOB ACCESSORIES
CARE AND MAINTENANCE OF THE

GLASS-CERAMIC HOB
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE

81

41902028GB.fm Page 82 Monday, October 11, 2010 11:04 AM

BEFORE USING THE GLASS CERAMIC HOB

• To make the most of your new appliance,

please read the user instructions carefully and
keep them handy for future consultation.

INSTALLATION

Cooktop

• The cooktop must be set into a worktop between
20 mm and 50 mm deep

• There must be nothing between the cooktop and the
oven (cross rails, brackets, etc.).

• The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 20 mm.

• If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop to the side of the column unit.

• Make an opening in the worktop, respecting the dimensions

indicated in the enclosed product description sheet.

• Apply the supplied gasket to the cooktop (unless it has already
been fitted), after having cleaned its surface.

Important

In order to prevent the electronic circuits from overheating, and
therefore from being damaged, we recommend the following:

• Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do not
come into contact with steam or moisture, which could
damage them.

If an oven (from our range of ovens) is installed beneath the
cooktop, make sure that it is equipped with a cooling system.

If the temperature of the electronic circuits exceeds the
maximum permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a tolerable
level, at which point it will be possible to switch the hob on again.

• Switch the hob off after use.

Front

Rear wall

82

41902028GB.fm Page 83 Monday, October 11, 2010 11:04 AM

INSTALLATION

Assembly

A) If the worktop is made of wood, use the appropriate

brackets, spring clips and screws provided.

• Position the 4 clips (A) around the cooktop frame, in the
slots provided, see Fig. 1

• Measure the centre of the vertical sides of the cut out a
shown in Fig. 2.

• Position the centre of the brackets (C) on the centre of the
side previously identified.

• The upper edge of the brackets must be flush with the
worktop surface.

• Secure using the 4 screws (B)provided that should screwed
into the pre-prepared holes.

• Insert the cook hob into the pre-prepared hole ensuring that
the clips (A) lodge into the bracket slots provided
(C Fig. 4 e 5).

Fig. 1

A

Fig. 2

C

B) If the worktop is made of marble or other materials

(plastic compounds, ceramics, stone, etc.), the hob must

be fitted by means of brackets code 4819 310 18528.
(to be ordered from After-Sales Service if not provided).

• Fit the hob into the worktop.

• Position the brackets (C) as shown in the figure, in

accordance with the thickness of the worktop.

• Secure the screws (E) in holes (D).

B

Fig. 3

A

Fig. 4

Fig. 5

Top min. 20 mm

To p ma x . 5 0 m m

83