BAUKNECHT BDO 93F B K User Manual
User and maintenance manual
EN
IMPORTANT SAFETY INSTRUCTIONS
These instructions are also available on the website: docs.bauknecht.eu
YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT.
This manual and the appliance itself provide important safety warnings that must be read and heeded at all
times.
This is the safety warning symbol, which alerts users to potential hazards to themselves and others.
All safety messages are preceded by the warning symbol and the following words:
DANGER
WARNING
indicates a hazardous situation which, if not avoided, will cause
serious injury.
indicates a hazardous situation which, if not avoided, could cause
serious injury.
All safety messages indicate the nature of the potential hazard/warning and how to reduce the risk of injury,
harm and electric shock resulting from improper use of the appliance. Always comply with the following
instructions:
• Installation and maintenance must be carried out by a qualied technician, in compliance with the
manufacturer’s instructions and the local safety regulations. Do not repair or replace any part of the
appliance unless specically stated in the user manual.
• The appliance must be disconnected from the mains before carrying out any kind of installation work.
• It is compulsory to earth the appliance (however, it is not necessary for class II hoods identied by the
symbol on the specications label).
• The power cable must be long enough to connect the appliance to the power supply socket.
• Do not pull on the power cable to unplug the appliance.
• After installation, the electrical components must not be accessible to the user.
• Do not touch the appliance with wet hands and do not operate it when barefoot.
• This appliance may not be used by children (aged 8 and above), persons with any physical, sensory or
mental impairment, or persons lacking experience or knowledge of the appliance, unless they are
supervised or given instruction on how to use it safely and are made aware of the hazards its use might
entail. Children must not play with the appliance. Cleaning and user maintenance must not be carried out
by children unless they are under adult supervision.
• Do not repair or replace any part of the appliance unless specically recommended in the manual. Any
defective parts must be replaced with original spare parts. All other maintenance work must be carried
out by a qualied technician.
• Children must be supervised to ensure that they do not play with the appliance.
• When drilling holes into the wall or ceiling, take care not to damage any electrical wiring and/or
pipework.
• Ventilation ducts must always discharge exhaust air to the outside.
EN3
• Exhaust air must not be discharged through a ue used for extracting fumes produced by gas-burning or
any other fuel-burning appliances; it must have a separate outlet. All national exhaust air regulations
must be observed.
• If the hood is used at the same time as other appliances that use gas or other fuels, the negative pressure
of the room must not exceed 4Pa (4x10-5bar). Please ensure, therefore, that the room is adequately
ventilated.
• The manufacturer does not accept any liability for inappropriate use of the appliance or for incorrect
setting of the controls.
• Regular maintenance and cleaning ensure that the appliance works correctly and achieves optimum
performance. Regularly clean all stubborn surface dirt, to avoid a build-up of grease. Regularly remove
and then clean or replace the lters.
• Failure to observe the instructions for cleaning the hood and cleaning and replacing the lters may result
in a re.
• The extractor hood must never be opened without the grease lters tted and should be regularly
monitored.
• If three or more gas cooking zones are in use, the hood should be set at power setting 2 or higher. This
prevents the build-up of excess heat in the appliance.
• Wear protective gloves when carrying out any installation and maintenance work.
• This product is not suitable for outdoor use.
• When the hob is in use, accessible parts of the hood may become hot.
KEEP THESE INSTRUCTION
EN4
Declaration of Conformity
• This product has been designed, manufactured and marketed in compliance with:
- the ecodesign requirements of European Regulations n. 66/2014, n. 327/2011, n. 244/2009, n. 245/2009, n.1194/2012, n. 2015/1428;
The appliance's electrical safety can only be guaranteed if it is correctly connected to an approved earthing system.
Energy saving tips
• Switch on the hood at the lowest speed setting when you start cooking and allow it to run for a few minutes after you have nished cooking.
• Only increase the speed if there is a lot of smoke or steam and only use the "Boost" setting(s) in extreme situations.
• Replace the carbon lter(s) when necessary, to maintain ecient odour reduction.
• Clean the grease lter(s) when necessary, to maintain eciency.
• Use a pipe with the maximum diameter specied in this manual, to optimise eciency and reduce noise levels to a minimum.
INSTALLATION
After unpacking the appliance, check that it has not been damaged in transit. In the event of problems, contact the dealer or your nearest After-sales Service. To
prevent any damage, only remove the appliance from its polystyrene base at the time of installation.
PREPARING FOR INSTALLATION
WARNING
The product must be installed in such a way as to ensure that the hood and electronic components are easily accessible should any maintenance operations need to
be carried out.
Position the metal box containing the electronic components at a distance of not less than 65 cm from the gas hob or in any case 65 cm from the hood suction point.
We recommend installing the metal box containing the electronic components at least 10 cm above oor level (e.g.: oven sides or hob).
Before installation, also check the minimum distances specied in the hob manual.
If the installation instructions for the hob specify a greater distance between the hob and the hood, this distance must be observed.
ELECTRICAL CONNECTION
Check that the voltage specied on the appliance identication plate is the same as the mains voltage.
This information is found on the inside of the hood, under the grease lter.
The power cable (type H05VV-F 3x0.75mm
If the hood is tted with an electric plug, connect the appliance to a socket which complies with current regulations and which is in an accessible location. If no plug
is tted (direct wiring to the mains), or if the socket is not in an accessible location, install a standardised two-pole circuit breaker that will allow complete isolation
from the mains in the event of category III overvoltage, in compliance with the wiring regulations.
If the cable is not tted with a plug, connect the wires according to the following table:
Mains voltage and
frequency
220-240V – 50Hz
GENERAL RECOMMENDATIONS
Before use
Remove any protective cardboard, transparent lm and adhesive labels from the accessories. Check whether the appliance has been damaged in transit.
Wire connection
: yellow/green
N : blue
L : brown
this appliance is heavy; the hood must be lifted and installed by two or more people.
2
) must only be replaced by an authorised electrician. Contact an authorised Service Centre.
During use
Do not place heavy items on the appliance as this may cause damage. Do not expose the appliance to atmospheric agents.
EN5
Loading...