BASELINE Kit 85607952 User Manual

Motorcycle Clamp and Adapter Kit 85607952

For use with BaseLine Tire Changers

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • www.ammcoats.com • www.baselinebycoats.com

Adapter Plate Installation

1. Remove existing “short bolt” from clamp assembly. Be sure

to keep the bushing and spring washer.

Pull latch out & rotate clamp to install or remove.

2. Position supplied adapter plate (85607949) onto clamp carrier.

40-45 ft. lbs.

Table Top Linkage

3. Use supplied “long bolt” (85607950) to reassemble clamp assembly.

ATV Clamp Kit Set of (4), Part # 8184414 Clamp Jaw Kit Pkg of (4), Part # 8184712

To Remove

Push latch in to lock in place.

4. Fit M/C clamp over existing clamp on table top &

push lock handle in place. Pull handle to release lock.

Note:

1) Air pressure should be regulated to 100 PSI maximum when using these accessories.

2) Always observe safe mounting procedure and use approved rubber tire lubricant liberally.

Lock Handle (Latch)

Specifications and Main Features