
Umbrella
Drain
• Push button pop-up with threaded body (1 pc.) • Nut • 1 Steel Washer • 2 Rubber Washers •
▪1-1¼” x 1¼” slip nut ▪ 1-1¼” beveled washer ▪ 1-1¼” x 8” or 12” tube extender
Note: The above parts are not needed if using FV washbasin traps: Model# U242 or U242.01.
Pop-up Instructions
Cat. No.
UD701
INSTALLATION INSTRUCTIONS
Parts Included
Parts Needed
The necessary parts are included with the washbasin trap.
Tools Needed
• Adjustable Wrench • Pipe Putty or Teflon Pipe Tape •
1. Put 1 rubber washer onto body, sliding it up to drain cap.
2. Place pop-up into sink drain hole.
3. Slide 2nd rubber washer onto body from below sink.
4. Slide metal washer onto body from below sink.
5. Thread nut onto body and tighten.
Connect drain to trap
1. If using FV’s washbasin trap (Model# U242 or U242.01) follow instructions included with trap.
2. If not using FV’s washbasin trap, use following instructions:
a. Slide the washer onto the tube extender.
b. Slide the slip nut onto the tube extender.
c. Place one end of the tube extender into the drain body.
d. Slide the slipnut up the extender until it meets the drain body.
e. Thread the nut onto the drain body and tighten until snug.
6/25/09
P 847•244•1234 www.barclayproducts.com