Undercounter
Basins
INSTALLATION INSTRUCTIONS
Tools Needed
• Pencil • Tape Measure • Jigsaw • Wrench • Hammer • Screwdriver • Drill •
Materials Needed
• Sink • Faucet • Drain Assembly • Supply Pipe & Fittings • Drain Pipe, Trap & Fittings • Silicone Sealant •
• Sink Clips (NOT Provided) •
• If possible, attach the drain to the lavatory before installation. |
|||
• Install the water supplies and drain piping according to the manufacturer. |
|||
• Verify cabinet clearance beneath the countertop to accommodate lavatory basin, |
|||
faucet valving, and drain piping. |
|||
• Cut out the template where indicated for the countertop opening. |
|||
• Cut along the inside of the cutting line. |
|||
• Position the template on the countertop to ensure clearance between the lavatory, faucet, |
|||
and backsplash. |
|||
• Trace around the template on the countertop with a pencil. |
|||
• Mark the faucet hole centerline on the countertop. |
|||
• Cut out the countertop opening by carefully following the pencil line traced from the template. |
|||
• Position the lavatory in the cut-out and verify the fit. |
|||
For Wood Countertops: |
|||
Be sure to waterproof any exposed areas of wood. |
|||
1. |
If the countertop has not been installed, install it at this time. |
||
2. |
Drill the faucet holes according to the faucet installation instructions. |
||
3. |
Install the faucet and drain according to the manufacturer’s instructions. |
||
4. |
Apply a continuous bead of quality sealant to the top surface of the lavatory |
||
|
rim where it will contact the countertop. |
||
5. |
Install the lavatory to the countertop with sink clips (not provided). |
||
6. |
Position the lavatory squarely under the cut-out before tightening the clamps. |
||
7. |
Draw the lavatory rim up against the countertop until it is snug. Do not overtighten. |
||
8. |
Immediately wipe away any excess sealant and fill any voids as needed. |
||
9. |
Allow the sealant to set for 30 minutes before proceeding. |
||
10. Connect and tighten the trap to the drain, and complete the water supply |
|||
|
connections to the faucet according to the faucet instructions. |
||
11. Run water into the lavatory and check for leaks. |
|||
|
NOTE: |
||
|
DO NOT tighten too much or you may damage bowl. |
|
|
9/16/08 |
P 847•244•1234 |
www.barclayproducts.com |