Barclay LS585, LS330, LS360, LS460 Installation Manual

Utility

Sinks

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

4/6/09

Tools Needed

• Pencil • Tube Cutter • Socket Wrench • Saw • Wrench • Hammer • Screwdriver • Drill & 3/8” Bit •

Materials Needed

• Sink • Faucet • Drain Assembly • Supply Pipe & Fittings • Drain Pipe, Trap & Fittings • Silicone Sealant •

NOTE:

DO NOT tighten too much or you may damage bowl.

1. Using a template 1/2” narrower than the sink rim, mark the counter top cut out. Drill a starter hole 3/8” inside of

circle and then use a saw to finish cutting the opening for the sink.

2. Place a bead of silicone caulk around the cut out opening. Install the drain assembly. Set the sink into the
opening. Press the rim down firmly. Hook up the drain and water supply fittings.

3. Tighten all connections, being careful not to over tighten. Check for leaks. Small leaks can be corrected by
tightening the nuts.

Cat. No.
LS330, LS360
LS460 & LS585