Balboa Water Group ADCM Hub User Manual

Balboa Menu Panel ADCM Hub System Installation

Description: The Balboa Menu Panel ADCM Hub System is the interface

between the EL/GL Spa Control and Balboa’s Menu Panels.

Mount the ADCM Hub System
box to a firm surface in the
equipment bay and connect
wires as described below.

Connect to Jensen Stereo Remote
Connection on Stereo unit.

Y-Cable 25482 must be added in
order to utilize a Dolphin Remote
for Stereo Control along with the
Menu Panel(s).

Connections (J9 & J10) are interchangeable
between the Spa Side Menu Panel and the
transceiver for the In-home Panel.

Jets 2Jets 1

J1

J2

BL

LT

102º F

LightBlower

HT

FC

OZ

Enter

Connect to ADCM Port J69
on EL or GL PCBAs Mach 3
or higher.

Replace cable clamp when
all wires are positioned in
separate slots.

When the ADCM Hub System box is connected
to the Spa Control system, use this connector
(J7) for FAST Testing. For firmware updates,
ESM must be plugged directly into the ADCM
port (J69) on the EL/GL system board while the
ADCM Hub System Box is disconnected.

(cont’d on reverse side)

Menu Panel Installation and Training Instructions for use with the ADCM Hub System

After installing the ADCM Hub System...

Adding a Spa Side Panel:

If you have a Spa Side Panel, turn off power to the Spa.
Insert the cable into J9 or J10 in the ADCM Hub System
box. Replace the cable clamp when all wires are connected
and positioned in separate slots. Turn power back on to
the Spa. The system will recognize the Spa Side Panel
immediately. The panel is now ready to use.

2

Jets 2Jets 1

J1

J2

BL

LT

LightBlower

102º F

Linking the Hand Held Panel to the Control System

The hand held panel must be added, or “linked”
before it will communicate with the system.
Proceed to “To Link Panel to the Spa Control System”.

HT

FC

OZ

Enter

Adding a Hand Held Panel:

If you have a Hand Held Panel, turn off power to

1

Replace the cable clamp when all wires are connected
and positioned in separate slots. Turn power back on to
the Spa. Proceed to “Linking the Hand Held Panel to the
Control System”.

3

To link your wireless panel to the system, press
Follow the on-screen instructions:

the Spa. Insert the transceiver cable into J9 or J10
in the Hub System box.

To Link Panel to the Spa Control System

“Home” Screen > Set >

> Link Panel > .

.

Shut off power to spa.

Turn spa power back on and

then push select on this

panel within 30 seconds.

Additional screens will follow: “Linking Panel...Please
Wait”; then, “Panel Linked Successfully”. “Starting Up” will

Select

also blink.

If the “Priming Mode” screen appears, follow the instructions.
You’ll probably choose “Exit Priming Mode” if you’re simply

To Exit all Menu Screens

except Fast Keys, Arrow Left

creating a link from the Wireless Panel to the Spa Control
System. Once completed, “Acquiring System Config.” will blink
on the Home display.

Warning! Shock Hazard! No User Serviceable Parts.

Do not attempt service of this control system. Contact your dealer or service organization for
assistance. Follow all owner’s manual power connection instructions. Installation must be
performed by a licensed electrician and all grounding connections must be properly installed.

p/n: 40828_B September 13, 2007