Bakbar E92 Installation Manual

SWIFTGRILL

Model: E92
Cooking Area: 696 x 450mm 27½" x 17¾"

INSTALLATION

IMPORTANT - FIXED WIRE INSTALLATIONS MUST INCORPORATE AN ALL­ POLE DISCONNECTION SWITCH.

All appliances are to be installed by a Qualified Person, who must check unit is operating correctly.
THIS APPLIANCE MUST BE EARTHED (GROUNDED). All installations are to be in accordance
with local health, safety and electrical requirements.

E92 for 220-240 Volts AC - 7200W 30.0 Amp at 240 Volts

A 3-wire 30 Amp cable should be fitted to this appliance for connection to a single phase 30 Amp
supply (Phase + Neutral + Earth).

Note: This appliance may also be connected to a 2 phase supply if required. Connection of the 2

phase supply should be in accordance with the circuit schematic alternative on this
instruction sheet.

OPERATION

This unit is designed for cooking food directly on the hotplate surface. The elements under the plate
are thermostatically controlled. The pilot light indicates when the element is heating.

FOOD TEMP
ºC ºF
Meat - Bacon 180 355

- Frankfurters 180 355

- Ham Slices 180 355

- Hamburger Patties 160 320

- Lamb Chops 190 375

- Steak 200 400

- Sausages 150 300
Eggs 140 285
Fish 190 375
French Toast 190 375
Griddle Cakes 190 375
Onions 180 355
Mushrooms 180 355

Turn the thermostat dial clockwise to the desired temperature. When the pilot light goes out, the
desired cooking temperature has been reached. Turning the dial to higher settings will not reduce
the heat up time. Model E92 has two controls, one for the left half and one for the right half.

CLEANING

After use the plate should be scrubbed with a brush detergent and water, and the grease drawer
emptied. To remove accumulated carbon, use a scraper and fine grit griddle brick. Occasionally
bleach plate with vinegar when cold.

Note: Do not use griddle brick on chrome plated griddles.

THIS APPLIANCE MUST NOT BE CLEANED WITH A WATER JET.

SERVICING: DISCONNECT POWER SUPPLY BEFORE SERVICING.

Remove grease drawer and turn unit upside down. Remove panel marked service access. Remove
4 nuts holding the base panel.

THERMOSTAT - Remove thermostat wiring, knob and mounting nut. Lift the control assembly over
the front of the unit and withdraw thermostat through cutout in the base panel. Remove element
clamps and insulation. Replace thermostat and position bulb under insulation strip. Refit insulation,
clamps, base panel and cover panel.

ELEMENTS - Remove element wiring, lift control panel assembly over the front of the unit and
remove element clamps. Replace element, wiring, insulation, clamps base panel and cover panel.

FUSES - 20 Amp - Remove fuse cover at back of control box.

SPARES

Spare parts are listed here. For parts not listed, please include model and serial number with a
description of the part when ordering.

DESCRIPTION MODEL E92
Element 220-240V 10280
Thermostat 11987
Knob °C 15563
Knob °F 14097
Pilot Light 13528

CIRCUIT DIAGRAM

NOTE: For 2 Phase, connect RH Thermostat to terminal marked L2.

F14017-8