Bakbar E84 Installation Manual

FOOD WARMERS

WARNING

CAUSE PRODUCT FAILURE.

unit is operating correctly. This appliance must be grounded

(earthed). All installations are to be in accordance with local Health,

Safety and Electrical requirements. Units fitted with cord and

appropriate plug can be connected directly to the supply listed below.

Model: E83 E84

4 Racks 493 x 295mm 4 Racks 693 x 295mm

: All appliances are to be installed by an electrician who must check

DO NOT OBSTRUCT THE AIR CIRCULATION BY PLACING ALUMINIUM FOIL OR

SIMILAR ON RACKS OR ACROSS THE BOTTOM OF THE CABINET AS THIS MAY

INSTALLATION

QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.

THE APPLIANCE MUST BE POSITIONED SO THAT THE PLUG IS ACCESSIBLE

IF SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY A SUITABLY

E83 for 220-240 Volts ac 800w 3.4 Amp at 240 Volts

E84 for 220-240 Volts ac 1100w 4.6 Amp at 240 Volts

OPERATION

This unit is designed to heat pre-cooked food to serving temperature, and keep it warm until

required.

doors cannot be opened. Remove if not needed.

The element is thermostat controlled. Turn thermostat dial clockwise to the desired level

(or on full until the desired temperature is reached, then turn anti-clockwise until the pilot

light goes out). The thermometer shows the temperature in the cabinet. The pilot light

illuminates when the element is on.

Place food on the racks provided, with space between to allow hot air to circulate.

NOTE: All models are supplied with a door retaining bracket. When fitted, the two rear

21117-4

THERMOSTAT
2

1

LIGHT

LIGHT

PILOT

ELEMENT

L

CIRCUIT DIAGRAM

ONLY

LIGHT MODELS

N

ARTH

E

CLEANING

Ensure power is disconnected.

Remove doors - lift up out of bottom channel and lower them out of top channel. (For full

glass back option, lift glass straight up). Remove racks after doors have been removed.

Remove element guard by lifting out.

Clean with a damp cloth and detergent.

Re-assembly is the reverse of steps above. To replace door locate top of door into top

channel and lower door into bottom channel. (See illustration)

THIS APPLIANCE MUST NOT BE CLEANED WITH A WATER JET.

DISCONNECT POWER SUPPLY BEFORE SERVICING

SERVICING

Remove racks, doors and element guard as described above. Turn cabinet onto its back or

top and remove base. Remove RHS end cap and RHS wraper for access to Thermostat.

SPARES

Door Glass 20960 20961

Spare parts are listed below.

For parts not listed please include model and serial numbers with a description of the part.

DESCRIPTION MODEL E83 MODEL E84

Glass Back Panel 20962 20963

Door Handle 18178K 18178K

Rack 20964 20965

Element 800W 21109

Element 1100W 21110

Thermostat 011980 011980

Knob 21112 21112

Thermometer 21113 21113

Pilot Light 13528 13528

Foot 21114 21114

End cap 20966 20966

Element Guard 21102 21103

Bulb 25W (Light Models Only) 14218 14218