Page 1
B90- LS 900mm Bench Top
B90S-LS 900mm Bench Top c/w Salamander Up-Stand
Assembly Instructions
B90-LS
B90S-LS
231534-1
Page 2
Assembly Instructions
Fitting the Up - Stand Assy to the Bench Top Up-Stand Models only:
a. Remove the 6 self tapping screws from the back
panel of the bench top and remove the back
panel.
b. Fit the upstand tubes down through the cutouts in the top
of the flue.
c. Secure the upstand tubes in position
with tap-tight screws supplied.
d. Fit the upstand support arms to the top of the upstand tubes and secure in
position with the tap-tight screws supplied.
g
n
i
r
u
c
s
e
w
S
e
r
c
S
19 December 2007
2
Part No 231534-1
Page 3
Assembly Instructions
e. Refit the back panel to the rear of the bench top
and secure in place with the 6 self tapping screws.
g
n
i
r
u
c
e
S
s
t
l
o
B
f. Remove the feet from the underside of the
salamander.
g. Place the salamander on the upstand
support arms and align the feet attachment
holes in the underside of the salamander with
the holes in the upstand support arms.
h. Secure the salamander to the support arms
with the bolts supplied and tighten securely.
i. Connect up the salamander to the gas / elec-
tric supplies as shown in the 'Installation and
Operation' Manual for the salamander.
19 December 2007
3
Part No 231534-1
Page 4
Assembly Instructions
Fitting Adjustable Feet / Rear Rollers to the Benchtop Legstand Models.
Fitting Rear Adjustable Feet to the Legstand:-
a. Secure the rear of the base tray to the rear
benchtop legs by screwing the two adjustable
feet supplied, into the base of the rear
benchtop legs.
b. Secure each adjustable foot, hand tight.
Fitting Rear Rollers to the Legstand:-
a. Fit the rear leg securing bolts up through the
centre of the rear leg housings to secure the
rear of the base tray to the rear cooktop legs
and tighten up the bolts using a 24mm
socket.
b. Fit the rear rollers to the rear leg supports.
c. Secure the rear rollers to the rear leg
supports using the locating screw supplied.
d. Tighten the screw using a 10mm spanner.
e. Lift the benchtop back onto its legs / rollers
and refit all griddle plates, open burners,
trivets and pot stands.
f. Adjust the adjustable feet to level the
appliance.
Bench
Top
Leg Mount
Points
Cooktop
Legs
Base Tray
19 December 2007
4
Rear Leg
Housing
Rear Leg
Securing Bolt
Adjustable
Foot
Roller
Locating Bolt
Rear
Roller
Part No 231534-1
Loading...