Baby Jogger ATS ALL TERRAIN SWIVEL User Manual

Assembly

Instructions

ATS All Terrain Swivel

• 360° Swivel Front Wheel For Extreme Maneuverability

• Air Glide Suspension System For Smooth
And Comfortable Ride

This product complies with ASTM F833-05a

Read these

instructions carefully

before use and

keep them for

future reference.

Your child’s safety may be

affected if you do not follow

these instructions.

For the sake of your precious cargo, please read
these warnings before using your stroller.

• WARNING: Prevent serious injury to your child by always using the
safety harness.

• WARNING: Any load attached to the handle affects the stability of the stroller.

• WARNING: It may be dangerous to leave your child unattended.

• WARNING: Recommended weight for seat pocket is 2 lbs. (1 kg.)
and basket is 10 lbs. (4.5 kg.). Excessive weight may cause a hazardous
unstable condition to exist.

• Unapproved accessories shall not be used.

• Always use your wrist strap – these strollers can really roll, and the
wrist strap gives you control if you should slip or fall down.

• The passenger should remain seated (no standing in the stroller).

• Watch out for cars – never assume that a driver can see you and your child.

• Intended for passengers up to five years of age.

• Total weight load recommended for this stroller is 75 lbs. (34 kg.)
(combined passenger and baggage weight.)

• This stroller seats one passenger.

• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer.

• Never use roller blades while using a Baby Jogger.

B

Frame

1. Unpack stroller from box and set wheels aside.

WARNING: Ensure all

locking devices are
engaged before use.

2a

2d

2b

2. Flip stroller so handle is laying on top and pull handle up until frame locks into position.

2c

1

Footplate

2. While holding onto footplate, push up

on stroller frame until handle is laying on
floor. This will allow you to look under
footplate in order to secure it to frame.

1. Lay footplate onto stroller frame.

You may need to remove lower
section of the seat to gain better
access.

3. Align the holes on the frame with the holes

on the footplate and secure with the screws.

NOTE: The footplate will come with two screws. If you are missing one, please give us a

call at 800.241.1848.

2

Front Wheel

Front Fork

Skewer Latch

1. To install front wheel, keep stroller with

handle resting on the floor and lock front
wheel forks by pushing down on locking
button on footplate.

3. Secure front wheel to frame by turning the front wheel

2. Insert the front wheel into forktips by

aligning the axle flats with the forktips flats
and inserting the skewer latch into the
stroller’s front forks.

lever while holding the lock nut on the opposite side.
Tighten until you feel tension on the lever and then
flip wheel lever over so that the word “CLOSED” is
visible. The wheel lever should face toward the rear

of stroller to prevent it from
getting accidentally caught on
something and opening up
during use.

Bring stroller frame back into
the upright position.

3