Baby Jogger ATS, ALL TERRAIN SWIVEL Assembly Instructions Manual

Read these

instructions carefully

before use and

keep them for

future reference.

Your child’s safety may be

affected if you do not follow

these instructions.

Assembly

Instructions

ATS All Terrain Swivel

• 360° Swivel Front Wheel For Extreme Maneuverability

• Air Glide Suspension System For Smooth
And Comfortable Ride

This product complies with ASTM F833-05a

B

• WARNING: Prevent serious injury to your child by always using the
safety harness.

• WARNING: Any load attached to the handle affects the stability of the stroller.

• WARNING: It may be dangerous to leave your child unattended.

• WARNING: Recommended weight for seat pocket is 2 lbs. (1 kg.)
and basket is 10 lbs. (4.5 kg.). Excessive weight may cause a hazardous
unstable condition to exist.

• Unapproved accessories shall not be used.

• Always use your wrist strap – these strollers can really roll, and the
wrist strap gives you control if you should slip or fall down.

• The passenger should remain seated (no standing in the stroller).

• Watch out for cars – never assume that a driver can see you and your child.

• Intended for passengers up to five years of age.

• Total weight load recommended for this stroller is 75 lbs. (34 kg.)
(combined passenger and baggage weight.)

• This stroller seats one passenger.

• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer.

• Never use roller blades while using a Baby Jogger.

For the sake of your precious cargo, please read
these warnings before using your stroller.

Frame

1

1. Unpack stroller from box and set wheels aside.

2. Flip stroller so handle is laying on top and pull handle up until frame locks into position.

WARNING: Ensure all

locking devices are
engaged before use.

2a

2b

2c

2d

2

Footplate

NOTE: The footplate will come with two screws. If you are missing one, please give us a

call at 800.241.1848.

1. Lay footplate onto stroller frame.

You may need to remove lower
section of the seat to gain better
access.

2. While holding onto footplate, push up

on stroller frame until handle is laying on
floor. This will allow you to look under
footplate in order to secure it to frame.

3. Align the holes on the frame with the holes

on the footplate and secure with the screws.

3

Front Wheel

1. To install front wheel, keep stroller with

handle resting on the floor and lock front
wheel forks by pushing down on locking
button on footplate.

2. Insert the front wheel into forktips by

aligning the axle flats with the forktips flats
and inserting the skewer latch into the
stroller’s front forks.

3. Secure front wheel to frame by turning the front wheel

lever while holding the lock nut on the opposite side.
Tighten until you feel tension on the lever and then
flip wheel lever over so that the word “CLOSED” is
visible. The wheel lever should face toward the rear

of stroller to prevent it from
getting accidentally caught on
something and opening up
during use.

Bring stroller frame back into
the upright position.

Skewer Latch

Front Fork

4

• To install rear wheels, push on
the button located at center
of wheel and gently slide the
wheel‘s axle into the hole in
the stroller‘s axle end until
you hear it click into place.

• To remove, simply push in on
the button located at center
of wheel while pulling out
the wheel.

Rear Wheels

IMPORTANT: To ensure the wheel is properly secured to the frame, test by trying to

pull the wheel out after installing.

5

1. Fasten front end of basket by securing

the basket snap straps around the frame
right above the footplate.

Basket

2. Now secure the back end of the basket

around the center bar on the stroller frame.

6

Seat

• Fasten the two bottom

Velcro straps to their
partner straps by threading
each Velcro strap through
the D-Ring and Velcro
back to themselves.

Your seat comes partially attached to the frame.

Please follow the steps below to finish securing it.

7

1. To recline: Pinch the clam and slide it down

the recline strap to desired angle and gently
push seat down with your hand.

2. To return to the upright position:

Hold the D-Ring on the end of the recline
strap in one hand and use the other to
pinch the clamp and slide it up the strap.

Reclining Seat

1. To secure

the beverage
holder onto
your stroller,
simply Velcro
straps around
handlebar frame
and Velcro back
to itself.

Beverage Holder

Store small items such as cell phone, keys and small wallets
in the zipper compartment so that they are not lost.

When installed the beverage
holder will look like this.

8

4. To adjust side straps: Press side buckle latch

and slide strap to lengthen or shorten.

Safety Harness

WARNING: Always use the crotch strap in combination with

the waist belt.

1. Unclip top of shoulder

strap from the seat and
re-clip on the pair of seat
loops closest to child‘s
shoulder height.

3. To buckle: Simply push side

buckle into center buckle until
it locks in place.
To unbuckle: Press one side
of the center button and pull
the corresponding side buckle
away from the center buckle.

2. To adjust the strap length:

Remove the shoulder pads
and move the plastic guide
up or down to lengthen or
shorten.

5. To adjust

the center
strap,
move its
plastic
guide up
or down.

9

3. For more ventilation, roll up one or both

of the side panel flaps and secure them
with the elastic loops.

2. To extend it to its fullest position,

simply unsnap canopy strap and
pull forward.

1. To use your

canopy simply
pull forward
to the desired
stage.

Canopy

4. Peek-a-boo window allows you to

check on baby without having to go
around the stroller.

10

WARNING: Engage parking device before loading and

unloading passenger.

Brake

1. Push center brake

pedal down to engage
rear parking brake.

2. To release rear parking

brake, simply lift up on
center brake pedal.

11

2. When handle is halfway, reach over and grab

the LIFT strap located on seat and pull up.

1. To fold stroller, simply squeeze fold latches

located near handle of stroller while
pushing down on handle.

Folding

12

Steering

• Steering your stroller is simple: It is balanced
to turn with just a light touch on the handlebar
without having to lift the front wheel.

Wrist Strap

• Make sure wrist strap is attached to bottom crossbar
and is secured properly around your wrist whenever a
child is in the stroller. The stroller is lightweight and ready
to roll – with or without you – and the safety wrist strap
helps you gain control over your stroller.

In the Dark

• Since we are concerned about the safety of you and
your child, we recommend that you not use your
stroller at night. However, if you choose to, please
attach reflective strips to the wheel spokes and the
seat. Bicycle lights can also be mounted on the handle
crossbar. These accessories can be found at most
bike stores.

In Motion

13

Washing

• You can machine wash your stroller’s seat in cold water with a mild detergent.
To minimize shrinkage, simply reattach the seat to the frame to dry.
(Please do not put the seat in the dryer!)

• Be sure to remove the frame from the back of the
seat before washing.

• The stroller frame can be cleaned using a soft,
dry cloth, and an occasional spray of household wax
will maintain its healthy glow.

Wheel Care

• Moisture – especially from the beach – can rust the wheel.
Spraying regularly with a silicone lubricant will keep your wheels

looking healthy.

Storing

• Sunshine can fade seat fabric and dry out tires, so storing
your stroller indoors will prolong its good looks. However,
if you do store it outside, using a tarp will help protect against
weather wear.

Stroller Care

We wish you many happy journeys with your new

stroller! Your stroller is a great product, and we

are proud to manufacture it. If you have any

questions or comments, please give us a call at:

BJC ATS 3/07

1.800.241.1848

Baby Jogger is a Division of Dynamic Brands

8575 Magellan Parkway, Suite 1000 • Richmond, VA 23227

T: 800.241.1848 • F: 804.262.6277

www.babyjogger.com

Thank You!