Azden SGMPDII User Manual

TWO-YEAR WARRANTY

Azden Corporation warrants, to the first purchaser, that the Azden brand product
purchased is free from defects in material and workmanship. Azden's sole obligation
under this warranty shall be to provide, without charge, repair or replacement
(at Azden's option), within two years from the date of purchase. A dated receipt acts
to establish the date of purchase.

This warranty is the sole and exclusive express warranty given with respect to the
product and all other express warranties are herby excluded. Neither AZDEN, nor
the dealer who sells this product, is responsible for indirect, incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you.

This warranty does not extend to any defect, malfunction or failure caused by misuse,
abuse, accident, faulty hookup, unauthorized modification or defective associated
equipment for which it is not intended. Please read your owner's manual carefully.

This warranty gives you specific legal rights. You may also have other rights which
vary from state to state.

To register this product, go to www.azdencorp.com/warranty "for North/South
America and EU customers.

Asia/Oceania customers contact with Azden distributors listed on www.azden.co.jp/global.html

SGM-PD II

OWNER’S MANUAL

Customers in the Asian and Oceania markets contact:

Azden Corp., 1-12-17 Kamirenjaku Mitaka-shi, Tokyo, 181-8533 Japan

voice - 81-1-422-55-5115(Japan) • fax - 81-1-422-55-0131(Japan)

email - [e-mail]

Customers in the North/South America and Europian markets contact:

Azden Corp., 147 New Hyde Park Rd, P.O. Box 10, Franklin Square, NY 11010

voice - 516.328.7500 • fax - 516.328.7506 • email - [e-mail]

© 2007 Azden Corporation

P1070-01 012-34207-01A

Printed in Japan

Professional

Phantom-Powered

Shotgun Microphone

Thank you for purchasing the Azden SGM-PD II

microphone. Designed for video and audio pro­fessionals, the SGM-PD II is a uni-directional shotgun
microphone with a wide frequency response and low
noise levels.

Power:

The SGM-PD II must be powered by Phantom­Power. To power the unit, connect an XLR cable to
the microphone from a voltage source that supplies
between 11 and 52VDC. (see wiring diagram below)

MIC Output:

The SGM-PD II has a balanced 3-pin XLR
connector.

Shoe-Mount Holder:

The SGM-PD II is supplied with a camera­mountable mic holder. Snap the near portion of the
microphone into the holder. To secure the holder,
slide the holder into the camera shoe and tighten the
thumbwheel by turning it clockwise.

SPECIFICATIONS:

Electret Condenser Microphone

Frequency Response 80-18,000Hz
Sensitivity –33dB at 1kHz (0dB=1V/Pa)
Impedance 130 Ohms at 1KHz
MAX SPL (Input Level) 120dB SPL (1kHz at 1% T.H.D)
Signal-To-Noise Ratio 70dB. (1kHz at 1Pa)
Power (Phantom-Power) 11
Current
Weight 110g

Dimensions

Connector 3-PIN XLR
Supplied Accessories Shoe-Mount Holder,

∼∼

∼ 52VDC

∼∼

∼∼

∼2.4mA

∼∼

3.88oz

∅ ∅

∅ 21mm x 150mm

∅ ∅
∅ ∅

∅ 0.827 x 5.9 inches

∅ ∅

Wind Screen, Pouch

Shield

Positive (Hot)

Frequency Response Super-Cardioid Polar Pattern

Negative (Cold)

Due to constant improvements, specifications are subject to change without notice.