AXTON AT-3LE Quick Setup Guide

Quick Setup Guide OMNI IR

AT-3LE, AT-5LE

Installation



Install at least 12” from Camera

For optimal performance each illuminator should be at
least 12 inches away from any ceiling mounted camera
to prevent light from going directly into camera.

1. Using a hole saw make a 2 1/4"
installation hole.

2. Install metal clips (provided) onto
opposite sides of the hole.

12”

ILLUMINATE THE NIGHT

4. Plug in power cord or PoE cable
illuminator should turn ON.

POWER

12 Volts DC

OR

PoE

POWER INPUT

cause permanent damage and VOID WARRANTY.

Ceiling height affects illumination



coverage, higher ceilings allow for
wider coverage.

Applying voltage other than the required range may

Remove Insulation To
Allow Proper Cooling

3. Remove at least 3" of insulation
around the light to allow proper
cooling.

draft stop cover.



QUESTIONS ? [phone] or [e-mail] │axtontech.com

If necessary use a recessed light

3"- 4" inches

Ceiling

LIGHT

9 ft Ceiling
3LE- 47’ x 47’

WARNING! Infrared light is not visible. Do not view directly with optical

instruments (magnifiers) or stare directly into the illuminator at close distance

Do not attempt to open or modify the light as this will void the warranty.

If you need a modification, electric or physical, contact us directly. We will let
you know if it can be done. All changes MUST be made at our factory.

12 ft Ceiling
3LE- 63’x 63’

20 ft Ceiling
3LE- 105’ x 105’

801 West Robinson Drive, Suite 500, North Salt Lake, UT 84054
q801/519-0500 < 801/519-0501 [e-mail]

Made in the USA

Lifetime Warranty