AVSL DM-X3 User Manual

DM-X3

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

RGB PAR Can DMX Controller

Item ref: 154.090UK

User Manual

Introduction

Controller for LED RGB products such as PAR cans and Lighting bars that have the first three DMX channels set to Red,
Green and Blue. The controller features six preset colours, a sound-to-light mode, and pre-set colour changing sequences
while also being about to adjusting the flash sensitivity.

Control Layout

1. COLOUR BUTTONS When COLOUR SELECT is active select a pre-set static colour from these options

2. HOLD COLOURS Stops any colour change or fade and holds the current colour until deactivated

3. COLOUR SELECT Press to activate the HOLD COLOUR or manual RGB Faders

4. PROGRAM SELECT Activates the Pre-set programs selected by FADER 1COLOUR SELECT PROGRAM SELECT

5. FADER 1 Adjusts red brightness or selects the internal program in program mode

6. FADER 2 Adjusts green brightness or selects the sequence speed in AUTO mode

7. FADER 3 Adjusts blue brightness or selects the strobe speed in AUTO mode

8. MIC Internal microphone for sound activation

9. AUTO Auto colour change. Use FADER 2 and FADER 3 toadjust change speed and strobe effect

10. SOUND ACTIVE Sound activated mode. FADER 3 adjusts microphone sensitivity

11. BLACKOUT Turns all light output off

Operation

Red Static

Green Static

Blue Static

L. Green Static

Purple Static

Cyan Static

White Static

Red Pulse

Green Pulse

Blue Pulse

Yellow Pulse

Purple Pulse

Cyan Pulse

Colour Switch

Hold Current Colour

Power supply

12Vdc, 500mA

Power consumption

3.6W

Dimensions

220 x 140 x 70 mm

Weight

0.81kg

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines.

Preset static colours

Press “COLOUR SELECT” button. A green LED above the button will indicate this mode is active.
You can then select a preset colour from: RED, ORANGE, YELLOW, GREEN, CYAN, BLUE, PURPLE, MAGENTA and WHITE
by pressing the desired button, or choose your own by using the RGB FADERS.

Internal programs

Press “PROG SELECT” button. An amber LED above the button will indicate this mode is active.
Use FADER 1 to select one of the programs listed below (from 0-255)

Use FADER 2 to adjust the speed of change or pulse speed
Use FADER 3 to adjust the flash speed of the light

AUTO mode

Press “AUTO” button and the green LED light will illuminate to indicate this mode is active.
The light effects will change colour at a set speed which is controlled by “FADER 2” from slow to fast.

SOUND ACTIVE mode

Press “SOUND ACTIVE” button and the red LED light above the button will illuminate to indicate
this mode is active. Use “FADER 3” to adjust the microphone sensitivity. The fixture will then
change colour when the beat of sound is detected

HOLD

Press the “HOLD” button and the RED LED above the button will illuminate to indicate this mode is active. When in hold
mode it will freeze all operations of any other buttons and sliders. The light effect displays a static colour. You must
release the “HOLD” button before any other operation can happen.

BLACKOUT

Press the “BLACKOUT” button and the amber LED will flash to indicate that blackout mode is in operation. It will turn off
all fixtures instantly and turn them back on again when deactivated.

Specifications

Errors and omissions excepted.

Copyright© 2013. AVSL Group Ltd.

154.090UK User Manual