AVSL CE22 User Manual

CE22 Enhancer/Exciter + Surround Processor

170.938

User Manual

Features:

 Switchable Surround Processor
 Independent Bass Processors with 2 modes
 Variable Enhancer/Exciter process blend
 Balanced or unbalanced signal path

www.citronic.com

Introduction:

1. Bass Processor IN/OUT switch and LEDs: CH A

2. Bass Processor LOW MIX control: CH A

3. Bass Processor MODE switch: CH A

4. TUNE frequency control: CH A

5. PROCESS control of Enhancer/Exciter mix: CH A

6. HIGH MIX Enhancer/Exciter amount: CH A

7. SURROUND PROCESSOR IN/OUT switch & LED

8. SURROUND PROCESSOR amount

9. Bass Processor IN/OUT switch and LEDs: CH B

10. Bass Processor LOW MIX control: CH B

11. Bass Processor MODE switch: CH B

12. TUNE frequency control: CH B

13. PROCESS control of Enhancer/Exciter mix: CH B

14. HIGH MIX Enhancer/Exciter amount: CH B

15. POWER switch

16. Voltage Selector

17. IEC mains inlet

18. 6.3mm jack output: CH B

19. XLR output: CH B

20. 6.3mm jack input: CH B

21. XLR input: CH B

22. XLR output: CH A

23. 6.3mm jack output: CH A

24. XLR input: CH A

25. 6.3mm jack input: CH A

Thank you for choosing this Citronic enhancer/exciter unit. This product has been designed to deliver professional audio
processing facilities with reliable and accurate function. In order to achieve the best results from this equipment and avoid
damage through misuse, please read and follow these instructions and retain for future reference.

Warning:

To prevent the risk of fire or electric shock, do not expose any part of the unit to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the unit – refer all servicing to qualified service personnel.

Safety

 Check that the supplied mains lead is in good condition and the supply voltage is correct.
 Ensure signal leads are of good condition and connected to appropriate inputs/outputs
 Do not allow any foreign particles to enter the unit through control or connector apertures

Placement

 Keep out of direct sunlight and away from heat sources.
 Keep away from damp or dusty environments.
 When rack-mounting, avoid placing heavy units above the unit and ensure all connectors are accessible

Cleaning

 Use a soft cloth with a neutral detergent to clean the casing as required
 Use a soft brush to clear debris from the control surface
 Do not use strong solvents for cleaning the unit.

Front Panel

Rear Panel