AVSL CCT500 User Manual
SPECIFICATIONS
Power supply
1.5V button cell (CR2032 supplied)
A4 frequency
440Hz
Frequency stability
±0.5cent
Tuning modes
Chromatic, Guitar, Bass, Violin, Ukulele
Tuning range
A0 (27.5Hz) to A6 (1760Hz)
Dimensions (not inc. antenna)
76 x 65 x 26mm
Weight (without battery)
28g
Display does not light or lights very dimly
Change battery for a new one
Display freezes and will not respond
Remove and replace battery after 30 seconds and try functions again
Tuner cannot detect notes
Move clip to a new position where vibrations can be detected
Adjust tuning of instrument up and down in pitch until a note is detected
Change battery for a new one if suspected to be low on charge
www.chordmusic.co.uk
CCT500 CLIP TUNER
(173.281)
User Manual
Important
Avoid exposure to high temperature, direct sunlight, moisture, strong magnetic fields and corrosive materials
Clean only with a dry, lint-free cloth and avoid rough handling or impact
Remove battery when not being used for long periods of time
ON/OFF button function
Press and hold the ON/OFF button for 3 seconds to switch on the tuner
The display will illuminate completely and then enter the tuning mode (whichever has been previously selected)
Press the ON/OFF button momentarily to scroll through the tuning modes (instrument types)
Press and hold the ON/OFF button for 3 seconds to switch the tuner off.
If no buttons are pressed and no tuning vibrations detected for 3 minutes, the tuner will power down automatically
Tuning
Switch on and select the correct mode for the instrument that requires tuning (see above)
Clip the tuner onto the instrument where it can pick up vibrations (e.g. on the headstock)
Rotate the display so that it can be seen during tuning adjustment
Play a note and check that the display to see if a note is detected
If no note is detected, adjust the tuning on the instrument or move the clip to another position until a note is detected
Adjust the tuning on the instrument until the required note is indicated (display shows string number and musical note)
Tuning accuracy is displayed via a virtual needle which is to the left when the note is flat and to the right when it is sharp
When the note is exactly in tune, the needle points to the centre and the backlight changes colour to green.
Repeat the tuning process for all strings and repeat again if strings need settling in or stretching
Troubleshooting
© Chord 2011
Loading...