AVSL CAB41PK User Manual
CAB41PK
1.
Bass input
5.
Treble control
2.
Master volume control
6.
Headphones output
3.
Bass control
7.
Auxiliary input
4.
Middle control
8.
Power switch
Power supply
230Vac, 50Hz (IEC) 18W
Output power
10Wrms
Dimensions
250 x 280 x 125mm
Weight
3.4kg
10W BASS AMPLIFIER
User Manual
Layout
Setting up and operation
Your CAB41 bass is supplied with a guitar lead with a 6.3mm jack on each end
Plug one end into the bass jack socket and the other end into the guitar input on the amplifier (1)
The bass amplifier is supplied with IEC lead(s) for connecting to the mains
Connect the IEC at the rear of the amplifier and the mains plug to an appropriate mains outlet
Turn Master volume (2) fully down and set Bass, Middle and Treble controls (3, 4, 5) to the 12 o’clock position
Switch the power on (8)
Play the bass with volume and tone controls turned fully up and gradually increase Master volume
The tone of the bass can be changed by adjusting the Bass, Middle and Treble controls (3, 4, 5)
A 3.5mm jack Aux input is provided for playing along to a track from an audio player
Connect a an mp3 player, smart phone or other line level source to the Aux Input and press play
Use volume controls on the playback device and bass to achieve the best volume balance of both
If silent practice is preferred, plug headphones in via the other 3.5mm socket, which will mute the speaker
After use, turn down Master volume and switch off power. Unplug from mains when not in use for long periods
Specifications
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.
GBT-7
1.
Internal microphone
4.
Power/Mode switch
2.
Note indicators
5.
Guitar/Bass input
3.
Flat/In-tune/Sharp indicators
Power supply
3Vdc (2 x AAA batteries)
Tuning modes
Guitar (6 or 7 string), Bass (4, 5 or 6 string)
Dimensions
96 x 50 x 17mm
Weight
34g (no battery)
GUITAR / BASS TUNER
User Manual
Layout
Note: Most guitars have 6 strings but some models have an additional low B (7 string)
Most basses have 4 strings but some models have an additional low B (5 string) and even a high C (6 string)
The GBT-7 has extended note range to handle these instruments in addition to standard types
Setting up
The GBT-7 operates from 2 x AAA batteries.
Slide open the rear battery cover and insert batteries as shown below
Operation
For electric instruments, plug in a jack lead from the instrument to the Guitar/Bass input (5)
Ensure that the instrument volume and tone controls are turned fully up
For acoustic instruments, place the GBT-7 internal mic. (1) within listening distance of the instrument sound-hole
Push the Power/Mode switch up to either Bass or Guitar setting, depending on the instrument to be tuned
The green “In-tune” LED will flash until a note is played. Pluck a single string to activate the tuner
When a sound is detected from the guitar or bass, the nearest note will be displayed on the Note indicators (2)
Tune the string to tension until the correct note is displayed for that string
When the correct note is displayed, use the Flat/In-tune/Sharp indicators to guide the tuning
When the note is flat (
Continue tuning adjustment until the green “in-tune” (>o<) LED is lit continually
Switch off when not in use and remove batteries if not used for long periods of time
b
), tighten the tuner slightly, when the note is sharp (#), slacken it slightly
Specifications
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.
Loading...