Avigilon 8.0MP-HD-DOME-180, 5.0MP-HD-DOME-D, 3.0MP-HD-DOME-DN, 2.0MP-HD-DOME-DN, 1.0MP-HD-DOME-DN Operating And Installation Instructions

Operating and
Installation Instructions

Avigilon Panoramic High Definition IP Dome Camera Model 8.0MP-HD-DOME-180

Avigilon Corporation
Vancouver
Canada

TEL [phone]
FAX [phone]

avigilon.com

2

This page is intentionally left blank.

3

Contents

Important Safety Information 4
Regulatory Notices 6

FCC Notice 6
Disposal and Recycling Information 6

Other Notices 7

Compilation and Publication Notice 7
Intellectual Property Notice 7

Overview 8

Cover View 8
Bottom View 9
Front View 10
Rear View 11
Heater View 12

Installation 13

Installation Steps 13

Package Contents 13

Required Tools and Materials 13
Removing the Dome Cover 13
Mounting the Dome Camera 14
Connecting Power 15
Aiming the Dome Camera 16
Connecting the Dome Camera to a Network Video Recorder (NVR) 16

IP Address Selection 17

Advanced Features 18

Upgrading the Firmware 18
Connecting to External Devices 19
Connecting to Microphones 20
Installing Replacement Dome Bubble 20

Cleaning 20

Body 20

Specifications 21
Limited Warranty & Technical Support 22
Notes 23

4

Important Safety Information

This manual provides installation and operation information and precautions for the use of
this equipment. Incorrect installation could cause an unexpected fault. Before installing
this equipment read this manual carefully. Please provide this manual to the owner of the
equipment for future use.

This symbol indicates the presence of dangerous voltage within and outside
the product enclosure that may constitute a risk of electric shock, serious
injury or death to persons if proper precautions are not followed.

This symbol alerts the user to the presence of hazards that may cause minor
or moderate injury to persons, damage to property or damage to the device
itself if proper precautions are not followed.

Warning – Failure to observe the following instructions may result in severe injury
or death.

Do not use the camera near water or expose the camera to dripping or splashing. Do not
place objects filled with liquids, such as vases above the camera.
Do not expose the camera to rain or moisture.
This camera is designed for indoor use only. For outdoor use, the camera must be
installed with an Avigilon DOME-OD-BASE or DOME-OD-PEND outdoor mount.
Installation of this camera must be performed by qualified personnel only and conform
to all local codes.
This product is intended to be supplied by a UL Listed Power Unit marked “Class 2” or
“LPS” or “Limited Power Source” with output rated between 12-24 VDC or 24 VAC, 12 W
min. or Power over Ethernet (PoE), rated 48 VDC, 12 W min.
Do not connect the camera directly to mains power for any reason.

•

•

•

•

•

•

5

Caution – Failure to observe the following instructions may result in injury or dam­age to the device.

Do not install near any heat sources such as radiators, heat registers, stoves, or other
sources of heat.
Do not subject the cables to excessive stress, heavy loads or pinching.
Do not open or disassemble the camera. The camera contains no user serviceable
parts.
Refer all servicing to qualified personnel. Servicing may be required when the apparatus
has been damaged, such as when liquid has spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, the apparatus does not
operate normally, or the apparatus has been dropped.
Do not use strong or abrasive detergents when cleaning the camera body.
Use only lenses and accessories recommended by Avigilon.
Avoid leaving the image sensor exposed for extended periods of time. Always cover the
image sensor with either a lens or a dust cap.
Do not allow dust, moisture or any other foreign debris to enter the lens mount.
Never touch the image sensor or any glass elements inside the lens mount.
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.

•

•

•

•

•

•

•

•

•

•

6

Regulatory Notices

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

This product complies with IEC 60825-1 (A2:2001) - CLASS 1 LED PRODUCT. Maximum
radiated output power: 740 mW.

FCC Notice

Note: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.

Changes or modifications made to this equipment not expressly approved by Avigilon
Corporation or parties authorized by Avigilon Corporation could void the user’s authority to
operate this equipment.

Disposal and Recycling Information

When this product has reached the end of its useful life, please dispose of it according to your
local environmental laws and guidelines.

European Union:

This symbol means that according to local laws and regulations your product
should be disposed of separately from household waste. When this product
reaches its end of life, take it to a collection point designated by local authorities.
Some collection points accept products for free. The separate collection and
recycling of your product at the time of disposal will help conserve natural
resources and ensure that it is recycled in a manner that protects human
health and the environment.

7

Other Notices

Compilation and Publication Notice

This manual has been compiled and published covering the latest product descriptions and
specifications. The contents of this manual and the specifications of this product are subject
to change without notice. Avigilon reserves the right to make changes without notice in the
specifications and materials contained herein and shall not be responsible for any damages
(including consequential) caused by reliance on the materials presented, including but not
limited to typographical and other errors relating to the publication.

Intellectual Property Notice

No license is granted by implication or otherwise under any industrial design, industrial design
rights, patent, patent rights, or copyrights of Avigilon Corporation or its licensors. Trademarks
and registered trademarks are the property of their respective owners.

Portions of the software in this product are licensed under the eCos License. Distribution
of eCos requires that the eCos source code be made available to Avigilon customers. The
eCos License and eCos source code are available to the public at http://www.avigilon.com/
ecoslicense. Avigilon reserves all rights to all software not covered under the eCos license.
This includes all portions of software that were not distributed to Avigilon as part of the eCos
operating system.

8

Overview

Cover View

Dome Cover

Tamper Proof Screws

Feature Description

Dome Cover Vandal proof dome cover constructed out of aluminum with a

polycarbonate bubble.

Tamper Proof Screws Torx tamper-proof captive screws used to fix the dome cover

to the base.

9

Bottom View

Cable Entry Hole

Serial Number Tag

Dome Mounting Slot

Dome Mounting Slot

Dome Mounting Slot

Feature Description

Cable Entry Hole Entry hole for all network, power and I/O cables.

Dome Mounting Slot Mounting points for the dome camera.

Serial Number Tag Serial and part numbers for the dome camera.