Avaya AP8120 User Manual

Nortel WLAN 8100

Regulatory Information - AP 8120

Release: 1.0 Document Revision: 01.AD

www.nortel.com

NN47251-104

Nortel WLAN 8100 Release: 1.0 Publication: NN47251-104 Document status: Draft Document release date: 10 February 2010

agreed to in writing NORTEL PROVIDES THIS DOCUMENT "AS IS" WITHOUT WARRANTY OR CONDITION OF ANY KIND, EITHER EXPRESS OR IMPLIED. The information and/or products described in this document are subject to change without notice.

Nortel, Nortel Networks, the Nortel logo, and the Globemark are trademarks of Nortel Networks. All other trademarks are the property of their respective owners.

Contents

Regulatory Compliance Statements 5

Federal Communications Commission (FCC) Compliance Notices 5

Canadian IC Statements 7 European Union and European Free Trade Association (EFTA) Regulatory

Countries of Operation and Restrictions of Use in the European Community 11

Antenna Statement 13

Class B Interference Statement 5 FCC Caution: 6 RF Radiation Exposure and Hazard Statement 6 Non-Modification Statement 6 Deployment Statement 6 Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands 6

Compliance 7 Declaration of Conformity 8 European Community Declaration of Conformity 9

Operation Using the 2.400 to 2.4835 GHz Channels in the European

Community 11

Operation Using the 5.15 to 5.25 GHz, 5.25 to 5.35 GHz, and 5.470 to 5.725

GHz Channels in the European Community 11 Dynamic Frequency Selection (DFS) 12 Transmit Power Control 12

English 15

Cable requirements 15 Mounting a wireless LAN access point on a wall 15 Installing an Access Point with a ceiling grid adaptor 16 Safety Messages 17

Nortel WLAN 8100

Regulatory Information - AP 8120

NN47251-104 01.AD Draft 10 February 2010

Nortel WLAN 8100

Regulatory Information - AP 8120

NN47251-104 01.AD Draft 10 February 2010

Regulatory Compliance Statements

The Avaya WLAN 8100 product line consists of the following models:

• AP 8120-A1

•

AP 8120-E1

This section contains regulatory compliance statements for these units.

Federal Communications Commission (FCC) Compliance Notices

This section includes the following FCC statements for the AP 8120-A1 access point:

• FCC ID:

• Class B Interference Statement

• RF Radiation Exposure and Hazard Warning

• Non-Modification Statement

• Deployment Statement

Class B Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

Nortel WLAN 8100

Regulatory Information - AP 8120

NN47251-104 01.AD Draft 10 February 2010

6 Regulatory Compliance Statements

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Radiation Exposure and Hazard Statement

To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 20 cm (8 in.) away from all persons. Using higher gain antennas and types of antennas not covered under the FCC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation instructions provided in this manual.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Non-Modiﬁcation Statement

Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage the AP 8120-A1 and violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device must be operated with the CAT-5 Ethernet cable installed on each activated Ethernet Port of an AP 8120-A1 access point to ensure compliance with the Class B emissions standards. Failure to comply with this installation requirement may cause the device to operate in excess of the allowable emissions limits

Deployment Statement

This product is certified for indoor deployment only. Do not install or use this product outdoors.

Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands

The AP 8120-A1 access point has been prohibited, via software, from operating in the 5250 to 5350 MHz and 5470 to 5725 MHz frequency bands for the US and Canada because it cannot meet the DFS requirements as outlined in the rules of the FCC for Part 15, Subpart E that come into force on July 20, 2007.

Nortel WLAN 8100

Regulatory Information - AP 8120

NN47251-104 01.AD Draft 10 February 2010

+ 14 hidden pages