864 ST Fireback Installation
SKU # 96100184 – 96100186 – 96100189 - 96100190
Packing List
• Floor Firebacks (4 pieces) • (2) Side Firebacks
Installation
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 Remove the glass frame and logs (see the installation manual for details).
2 Remove the front and rear grates (see the illustration below).
1/4" Nutdriver
Remove the grate from both sides.
NOTE: lift the burner to remove the grate.
3 Remove and discard the steel ember trays.
Remove and discard the steel
ember trays.
Page 1 of 2 9/15/08 Travis Industries, Inc.
4 Carefully place the floor
firebacks into position.
You must tip them under
and around the corners of
the burner.
5 Carefully replace the front
and rear grates (they rest
on top of the floor
firebacks).
WARNING:
When replacing the grate
do not drag the grate
across the firebacks (they
damage easily). You may
need to lift the burner
slightly while installing the
grate.
864 ST Fireback Installation
SKU # 96100184 – 96100186 – 96100189 - 96100190
NOTE: These tabs are bent out when using the accent light. Make sure
to carefully bend them flush if the accent light was previously installed
(then reposition them after firebacks are installed).
6 Install the side firebacks
following the directions
below.
7 Restore the fireplace to
the correct configuration.
Remove the clips on both sides (loosen the screws
a
a couple turns and slide clips up and out).
5/16" Nutdriver
Place the side firebacks into position.
b
Secure the clips to anchor
c
the side firebacks.
The ceramic firebacks are fragile. Ensure proper alignment of individual pieces in each
step. To achieve the ideal appearance, you may need to make slight adjustments.
Page 2 of 2 9/15/08 Travis Industries, Inc.