Autostart CTR433, RTR433 Users Manual

Please review the installation guide before beginning the installation, particularly the wiring diagram and the list of programming options.

Prior to installation please be sure that all hardware components required to install the AS-1200 are in the box. This is a list of components included in the AS-1200 kit:

• 1 - AS-1200 control unit

• 1 - 2 button / 3 channel remote transmitter

• 1 - 5 Pin 14 AWG harness (Ignition harness)

• 1 - 7 Pin 18 AWG harness (Main harness)

• 1 - 4 Pin / 2 Wire 18 AWG harness

(Accessories)

• 1 Antenna

• 1 Parts Bag (hood switch, valet switch,

connector, wires)

• User guide, tech bulletins.

FEATURES

§ Dual 12 volt power lines.

§ 12 volt parking light output.

§ 2 Button / 3 channel transmitter.

§ Factory alarm control.

§ Gasoline or Diesel engine ready.

§ Positive and Negative door lock output.

§ Cold weather timer.

§ Negative trunk output.

§ Up to 600 feet range.

§ 300 milliamp ground output (pulsed or

constant)

§ 300 milliamp ground when armed output.

§ External trigger control (From external

receiver. e.g.: alarm)

OPTIONS

NOTICE:

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

INSTALLATION POINTS TO REMEMBER

• When working on a vehicle always leave a

window open.

• Remove courtesy light fuse if possible to

prevent battery drain.

• Never Install control unit where it could

interfere with normal operation or obstruct service technicians.

• Do not disconnect the battery on vehicles

equipped with air bags and anti-theft radios.

• Always use a grommet when running wires

into the engine compartment. Never run wires through bare or sharp metal.

• Always solder and tape all connections.

• Never ground control unit to vehicle steering

column.

• Make sure that vehicles equipped with

automatic transmission do not start while in any of the drive gears. (If it will start in gear

please install a manual transmission starter)

• Remote keyless entry

• Remote Trunk release

• Engine kill

• Flashing LED

• Pager Ready

• 3 YEAR LIMITED WARRANTY

PROGRAMMABLE OPTIONS

• Door lock pulse duration ( 1 sec, 4 sec, or

two ¼ sec unlock pulses).

• Ignition controlled door locks.

• Constant or pulsed Groundout when

running.

• Run time (5,15, or 25 minutes)

• Maximum crank duration (6,8, or 12

seconds).

• Childproof operation.

• Gasoline or Diesel engine operation.

TRANSMITTER CODE LEARNING

AS-1200 transmitters do not come preprogrammed. They must be “CODE LEARNED” at the time of installation. The unit will hold up to 4 transmitter codes in memory.

To program a new transmitter:

1. Raise the hood

2. Turn valet switch “off”.

3. Turn ignition “on”.

4. Turn valet switch “on”.Parking lights will

turn on for 5 seconds.

5. Press either button on transmitter within 5

seconds of step 4. (lights will flash 5 times fast, and 2 times slow)