Autostart RLED4 Users Manual

AUTOMATIC TRANSMISSION REMOTE STARTER

AS-2300TW

User Guide

Table of Contents

Table of Contents ...................................1 Panic Mode........................................... 10

Important Information.............................. 2 Quick LockoutTM.................................... 11

Introduction............................................. 2 Cold Weather Mode.............................. 11

Using the Remote Control ......................2 Advanced Features: Installation-

programmable Options ......................... 11 Feature Confirmation Chart .................... 4

Vehicle Status Request .......................... 4 Remote Door Locks.............................. 12

Run Time Status..................................... 6 Priority Door Access .............................12

Run Time Cycles .................................... 7 Active or Passive Arming...................... 12

Using the Transmitter to Access Features

................................................................ 7

Remote-Starting Your Vehicle ................ 8 Flashing LED........................................ 12

Remote-starting ...................................... 8 Safe Start.............................................. 12

Vehicle Presets....................................... 8 Home Valet TM....................................... 12

Driving Off............................................... 8 Ignition-Controlled Door Locks .............13

Using the Remote Starter ....................... 8 Ignition Re-lock..................................... 13

Arming the Starter Kill............................. 8 Secure Lock.......................................... 13

Idle Mode................................................ 9 Turbo Mode .......................................... 13

Turbo Mode ............................................9 Remote Trunk Release......................... 13

Valet Mode.............................................. 9 Engine Run Time.................................. 13

Valet Mode Using the Valet Switch......... 9 Extended Run Time.............................. 13

Ignition Valet......................................... 10 Multi-car Operation ...............................13

Remote Valet Mode.............................. 10 Troubleshooting Poor Transmitting Range

” Mode ........................... 10

The Starter Kill and the Anti-grind Feature

.............................................................. 12

.............................................................. 14

“Home Valet

DOC:.1.00 – July 8, 2004 CA LP Manufactured in Canada by Autostart

FCC USER NOTICE (U.S.A.):

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.

Important Information

The boxes below contain information concerning your transmitter and remote starter. We entered the part number of your transmitter for you. Should you need to order a new transmitter, you will need to provide the transmitter part number which is printed below. The second box contains the serial number of the remote starter. Please make sure that the installer has entered the serial number in that box.

Transmitter part number: AS-5100TW HHU

Car unit: AS-5100TW IVU

The installer must use the space below to write the serial number of the remote starter and the location of the valet switch (if installed):

Serial number of the remote starter:

Location of the valet switch (if installed):

Introduction

This is a state-of-the-art remote starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features)and the Safe Start children safety feature. With many an advanced function, this product will satisfy any one your expectations from high-end commodity and security systems, without neglecting any standard feature commonly offered by entry-level starters.

Using the Remote Control

Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page

13). The functions of the transmitter are as follows:

P. 2 User Guide AS-2300TW

Pressing the SHIFT button and then the LOCK button will activate the AUX 2 output.

AS-2300TW Guide d’installation P. 3

Feature Confirmation Chart

Feature LED #1 LED #2 LED #3 LED #4 Beep(s)

Lock 3 flashes X X X 1

Unlock X 3 flashes X X 2

Trunk X X 3 flashes X 1

LED ON/OFF 3 flashes 3 flashes X X 1

Start X X X X 1

Running X X X 3 flashes 3

Stop X X X 3 flashes 2

Entering Cold

Weather Mode

Exiting Cold

Weather Mode

X X X 3 flashes 2

X X X 3 flashes 1

Home Valet 3 flashes X X 3 flashes 2

Valet Mode 3 flashes X X 3 flashes 1

Exit ValetMode X 3 flashes X 3 flashes 1

Vehicle Status Request

The status request feature allows the user to see the status of the vehicle (doors locked or unlocked, vehicle in cold weather mode, vehicle in home valet or vehicle in valet mode). The following chart indicates the confirmations that the user will receive on the transmitter. To retrieve the vehicle status, press and release the release the

TRUNK button (there will be a beep). At this point, the transmitter will flash the

corresponding sequence of LEDs depending on the vehicle’s status. The status request feature is made up of a two-step transmission:

• The first sequence of LED flashes will let you know if the vehicle is locked or

unlocked.

• The second sequence of LED flashes (if applicable) will let you know if the vehicle is

in any of the following statuses:

a) Cold weather mode, b) Home valet mode, or c) Valet mode

• If there was no second sequence transmission, this means that the vehicle is not in

any of the three (3) listed features (Cold weather mode, Home valet mode or Valet mode).

SHIFT button then press and

P. 4 User Guide AS-2300TW

(Available only when the vehicle is not running)

STATUS SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s)

Lock

Unlock

3 flashes X X X 1

X 3 flashes X X 1

1st

Vehicle Status Chart

sequence if

3 flashes X X X 2

locked

Cold

Weather

1st

sequence if

X 3 flashes X X 2

unlocked

sequence

X X X 1 second

1st

sequence if

3 flashes X X X 2

locked

Home

Valet

1st

sequence if

X 3 flashes X X 2

unlocked

sequence

1 second X X 1 second

1st

sequence if

3 flashes X X X 1

locked

Valet

Mode

1st

sequence if

X 3 flashes X X 1

unlocked

sequence

1 second X X 1 second

AS-2300TW Guide d’installation P. 5

+ 9 hidden pages