Autostart GNTR474 Users Manual

AUTOMATIC TRANSMISSION MULTI-CHANNEL REMOTE STARTER SYSTEM

AS-1414iHF/ AS-

1424iHF

User Guide

FCC/IC NOTICE:

This device complies with Part 15 of the FCC R ules, and RSS-210 of the IC rules . Operation is s ubject
to the following two conditions: (1) this device may not c ause harmful interference, and (2) this devic e
must accept any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.

DOC: 1.00 January 25, 2007 DL Lp Manufactured in Canada by Autostart

It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible manner.

1. When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in
“Park” in order to avoid accidents upon remote starting.

2. It is the user's responsibility to ensure that the remote
starter is disabled or put into valet mode before
servicing.

WARNING

Table of Contents

Introduction.............................................2

Basic Remote Operation........................ 2

Vehicle Presets.......................................3

Heater and Heated Seat.......................3

Windshield Wipers, Radio and

Headlights.............................................3

Remote-starting Your Vehicle................3

Remote-starting....................................3

Driving Off.............................................3

Remote Starter Features........................ 3

Idle Mode..............................................3

Valet Modes..........................................4

Panic Mode...........................................4

Cold Weather Mode..............................5

Advanced Features: Installation-

programmable Options.......................... 5

Arming the Starter Kill...........................5

Remote Door Locks.............................. 5

Priority Door Access.............................6

Ignition-controlled Door Locks Option... 6

Secure Lock Option..............................6

Remote Trunk Release Option.............6

Starter Kill / Anti-Grind.......................... 6

Engine Run Time.................................. 6

Multi-car Operation...............................7

Troubleshooting Poor Transmitting

Range Issues...........................................7

LIMITED LIFETIME WARRANTY............ 8

Introduction

This module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Please Note:

• The AS-1414iHF system is equipped with one

4-button multi-channel transmitter.

• The AS-1424iHF system is equipped with two

4-button multi-channel transmitters.

Basic Remote Operation

The system is equipped with a 4-button multi-channel transmitter.

The functions of the transmitter are as follows:

P. 2 User Guide

Vehicle Presets

Heater and Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
on

LOW or MEDIUM instead.

Windshield Wipers, Radio and Headlights

HIGH. It is recommended to leave the settings

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are off. Leaving the headlight switch
ON

on certain types of vehicles could cause them to remain on even after the remote starter

shuts down, resulting in a dead battery.

Remote-starting Your Vehicle

Remote-starting

Press the START/STOP button for approx. 1 second. The parking lights will come ON, informing
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
parking lights will remain

ON during the pre-programmed run time.

If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Driving Off

With the vehicle running under remote control, press the UNLOCK button to DISARM and UNLOCK
the doors (if installed). Enter the vehicle and do the following:

• Turn the ignition key to the IGNITION ON (RUN) position.

• Press the brakes to disengage the remote starter unit.

You are now ready to drive off.

Caution: do not turn the key to the CRANK position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the start kill / anti­grind feature (optional).

Remote Starter Features

Idle Mode

This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the IGNITION switch. The vehicle will keep running for the pre­programmed run time, or until it is shut down by remote.

Caution: Do not leave children or pets unattended in a car running in idle mode.

To activate Idle Mode:

To enable idle mode, press and hold the

LOCK, UNLOCK or START/STOP button on your remote

transmitter while the engine is running.

Note: When enabling idle mode, pressing

LOCK or UNLOCK will automatically unlock the

doors.

User Guide P. 3