Autostart AS2201 Users Manual

AUTOMATIC TRANSMISSION MULTI-CHANNEL REMOTE STARTER SYSTEM

AS-1412

User Guide

Transmitter Part Number and Serial Number of

the Remote Car Starter Module ........................2

Introduction .......................................................2

Remote-starting Your Vehicle ...........................2

Vehicle Presets.............................................2

Driving Off.....................................................2

Idle Mode ......................................................2

Valet Mode ........................................................ 3

Ignition Valet .................................................3

Valet Mode Using the Valet Button...............3

Panic Mode...................................................3

Cold Weather Mode ......................................4

Advanced Features........................................... 4

Remote Door Locks ...................................... 4

Arming the Starter Kill...................................4

Installer-programmable Features...................... 5

Remote Door Locks Option ..........................5

Ignition-controlled Door Locks Option ..........5

Secure Lock Option ......................................5

Remote Trunk Release Option ..................... 5

Engine Run Time .......................................... 5

Starter Kill / Anti-Grind .................................. 5

Troubleshooting Poor Transmitting Range Issues

..........................................................................6

Please note:

Button Ι is for the LOCK/UNLOCK functions.
Button ΙΙ is for the START/STOP functions.
Buttons Ι & ΙΙ (together) is for the TRUNK release function.

The LED is NOT included in this model.
The valet button is optional.

FCC USER NOTICE (U.S.A.):

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.

DOC.1.51 CA July 31, 2006 Manufactured in Canada by Autostart

Transmitter Part Number and Serial Number of the Remote Car Starter Module

The boxes below contain information concerning your transmitter and Remote Car Starter.
We entered the part number of your transmitter for you. Should you need to order a new
transmitter, you will need to provide the transmitter part number which is printed below.
The second box contains the serial number of the Remote Car Starter. Please make sure
that the installer has entered the serial number in that box.

Transmitter Part Number: ASRA-2201G-100

The installer must use the space below to write the serial number of the Remote Car Starter
and the location of the valet switch (if installed):

Serial Number of the Remote Car Starter:
Location of the Valet Switch (if installed):

Introduction

This Module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Remote-starting Your Vehicle

Press the ΙΙ button for approx. 1 second. The parking lights will come on, informing you that
the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking
lights will remain on during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on

LOW or MEDIUM instead.

on

HIGH. It is recommended to leave the settings

Windshield Wipers, Radio and Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are

OFF. Leaving the headlight

switch on on certain types of vehicles could cause them to remain on even after the remote
starter shuts down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press button Ι to DISARM the module and to

UNLOCK the doors (if installed). Enter the vehicle and do the following:

• Turn the ignition key to the IGNITION ON (RUN) position.

• Press the brakes to disengage the remote starter unit.

You are now ready to drive off.

Caution: do not turn the key to the CRANK position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti­Grind Feature (Optional).

Idle Mode

This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the

IGNITION switch. The vehicle will keep running for the pre-

programmed run time, or until it is shut down by remote.

P. 2 User Guide AS-1412