Autocue SSP07 User Manual
Mounting the Camera
Straight-read Assembly
1. Place your SSP07 on a smooth, level
surface. Remove the thumbscrews holding
the hood and monitor mounng plate.
2. Remove the two thumbscrews
attaching the monitor mounting
bracket to the drop bracket.
SSP07
Prompter
Guide
Mount the camera to the camera mounting bracket
using the 1/4” BSW camera screw, slide the camera
forward and ensure that the lens is inside the hood.
Use the hood slide screw to centre the lens inside
the hood and place the black light excluder around
the lens. Secure it using the drawstring.
Camera Balancing
A
A
Mount the unit with
camera attached to the
tripod and slide the unit
back and forth until you
achieve a balance.
Then retighten the
screws.
Loosen the two screws
(marked A in the picture) so
that the hot shoe plate will
slide back and forth.
3. Remove the thumbscrews
securing the monitor to the
monitor mounting bracket.
4. Align the bolt on the back of
the monitor mounting plate with
the hole in the centre of the drop
bracket.
5. Secure it to the drop plate
with the knob.
6. Attach an optional pistol
grip to the hot shoe plate on
the underside of the SSP07
unit.
7. Now attach your camera
to the camera mounting
bracket using the screw
supplied.
autocue.com
Camera screw
Components
g. i
g. ii
H
Vertical position
I
11. Attach the large plug
to the socket on the side
of the monitor.
12. You can use either a
composite or VGA video
input by connecting the
appropriate cable.
VGA (using
adaptor cable)
Video
Power 12V DC
A
C
Hood and glass
A
Monitor
B
Hood Bracket
C
Camera Bracket
D
Hot Shoe Plate
E
5. Attach the tripod camera mounting plate
to the hot shoe plate on the underside of
the SSP07 unit.
Drop Bracket
F
Monitor
G
mounting plate
Hood
H
thumbscrew
Hood Slide
I
Screw
B
G
D
E
F
Assembly
1. Remove the unit from its case
and carefully place the glass
side face down, onto a level
surface.
2. Loosen the thumbscrews holding the monitor
mounting plate and raise the monitor.
3. Align the metal tongue of the monitor mounting
plate with the slot in the drop bracket and carefully
insert the tongue into the slot. (fig. i)
4. Tighten the thumbscrews to secure the monitor
mounting plate. (fig. ii)
6. Slide the on-camera
unit onto your tripod.
7. Loosen the two thumbscrews
holding the monitor mounting plate
and hood assembly.
8. Raise the hood assembly to
the vercal posion and ghten
the thumbscrews.
9. Rotate the camera bracket so that it is on the
top of the unit and behind the hood.
10. Fix your camera to the bracket using the
camera screw. Slot the bracket over the
thumbscrews and tighten all four thumbscrews to
secure it.
Loading...