Autocue PS MWA Hood User Manual
1. Detach the upper glass
retainer by removing the
thumbscrews at either end.
2. With the blue dot in the
corner of the glass facing
you, place the shorter edge
of the glass into the lower
glass retainer in the bottom
of the hood.
Display Compatibility
PSP 12” and
17” Monitor
Professional
Series Hood
Medium Wide Angle
Guide
3. Re-attach the upper glass
retainer, placing it on the top
of the hood to hold the glass
securely in place and re-attach
with the thumbscrews.
Light excluder fitted
4. Carefully stretch the
elasticated end of the fabric
light excluder around the four
posts on the rear of the metal
frame.
iPad Display
Tablet PC
Display
For more compatible
monitors see our website.
autocue.com
Components
A
C
D
B
Hood Assembly
2. Re-tighten the four
studs to secure the frame
and clamp each side in
position. On the back of
the metal frame, halfway
down each side, there is
a large hole adjacent to
a small recess. In one
end of each tube clamp
is a thumbscrew and a
small metal locating pin.
Upper glass
A
retainer
Lower glass
B
C
D
1. Fold back the sides of
the hood and loosen the
four studs on the metal
frame. Insert the side
panels between the front
and back sections of the
metal frame. Ensure that
they are pushed in
completely.
retainer
Glass
Tube clamp
3. Align the tube clamp
with the two holes in the
back plate of the hood.
4. From the inside of the
hood, insert two screws and
tighten to secure the tube
clamp in position.
Repeat for the second tube
clamp.
Bracket Set Assembly
A
A
B
C
B
C
1. Ensure the keyhole plate
is in the appropriate
position on the bracket.
2. Screw in the vercal
hood mounting bars.
3. Screw in the
horizontal monitor
mounting bars.
Completed bracket
Keyhole Plate
Hood Poles
Monitor Poles
Align the hood
mounting bars with the
clamps on the rear of
the hood, pass the
tubes through the
clamps and tighten
using the knobs.
Loading...