Autec E16STXUS1 Users Manual
1Description
A
E16STXUS1 guide
D
A
B address key
C DIP switches
E16STXUS1 guide
connector for interface card or
keyboard
B
C
D antenna
2Programming
The transmitting module E16STXUS1 has two groups of DIP switches: a group of 4 and a
group of 8 DIPs. They program some functions and set the working frequency.
The Autec programming set in the other group of four dip switches must never be modified.
The group of eight dip switches located on the radio module are used to program some functions and set the working frequency.
DIP STATE FUNCTION
ON The transmitting unit never switches off automatically
1
OFF
If the transmitting unit stays switched on without any movement
commands entered, it switches off after approx. 3.5 minutes
ON Deactivation of low battery warning from horn on machine
2
OFF Activation of low battery warning from horn on machine
ON
If DIP 8 is OFF automatic scan of the frequencies in the band 915 928 MHz
3
OFF
If DIP 8 is OFF automatic scan of the frequencies in the band 902 -
915 MHz
3-7 ON/OFF If DIP 8 is ON see “Frequency Table”
ON
Manual selection mode of the frequencies using DIP 3 - DIP 7 (refer to
“Appendix: Frequency Table”)
8
OFF
Automatic scan mode of the frequencies in the band selected by DIP 3
(DIP 4 - DIP 7 indifferent)
1
E16STXUS1 guide
In order to work correctly, the following DIP switches in the transmitting module E16STXUS1
and in the receiving module E16SRXUS1 of the radio remote control units must be set in the
same way.
MODULE DIP
E16STXUS1
(group of 8 DIP
2345678
switches)
E16SRXUS1
(group of 8 DIP
2345678
switches)
3 Frequency table
4 Antenna position
The position of the E16STXUS1 antenna depends on the transmitting unit: the antenna can be
folded to fit the space inside the transmitting unit but it must never be unsoldered from the
module.
5Installation
Autec maintains control of the assembly of the E61STXUS1 modules into the its transmitting
units.
It is forbidden any other type of use or installation by anyone.
6Replacement
It is possible replace the E16STXUS1 transmitting module in the transmitting unit only by
authorized personell which knows the procedure related to the specific transmitting unit.
7IC warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
2
Loading...