AUSTRALIAN MONITOR IMGC450 Instruction Manual
INSTRUCTION MANUAL
IMGC450
Gooseneck Microphone
Thank you for purchasing this quality Australian Monitor product.
The IMGC450 is the finest gooseneck microphone Australian Monitor has released.
This premium electret condenser microphone is tailored specifically for voice
reproduction, providing a neutral tone and transparent response. The cardioid polar
pattern of the IMGC450 provides exceptional gain before feedback. Users will
enjoy fuss-free setup with minimal EQ manipulation, ensuring maximum
SPL for that all-important presentation.
This premium microphone is highly recommended for conference rooms,
board rooms, meeting rooms, houses of worship, school halls and
many other presentation applications.
What’s in the box?
1 x IMGC450 Gooseneck Microphone
1 x Isolated shock mount
3 x Self tapping screws for
shock mount installation
1 x Windsock
The instruction manual
you are now reading
Features
Tailored for Voice reproduction
High Sensitivity
Exceptional gain before feedback
Discreet unobtrusive slim design
RF Shielded
Low Frequency Filter
Phantom Power 9 – 52 V
The shock mount is designed to be flush-mounted and provides isolation to reduce
room-rumble and mechanical noises from being amplified.
Installing IMGC450 into the Shock Mount
1
To install the IMGC450 into the Shock Mount unscrew the
bottom plastic screw collar.
2
Slide the IMGC450 body into the Shock Mount.
3
Re-install the bottom plastic screw collar until snug.
Be careful not to cross thread or crack the plastic screw collar.
4
Insert a female 3-pin XLR connector into the microphone base.
5
Phantom power is required for the IMGC450 to operate.
To avoid possible loudspeaker damage ensure the PA system
is muted first before you enable phantom power.
Installing the shock Mount
1
Choose a suitable flat surface to install the shock mount.
2
Using a hole saw cut a 51mm (2inch) diameter hole through
the mounting surface
3
Slide the shock mount into the freshly cut hole and mark the
location of the three screw holes using a marker or punch.
4
Using a 3.0mm drill pre-drill three pilot holes.
5
Insert the shock mount into the hole again and fasten down
the shock mount with the 3 screws provided.
PAGE 2 PAGE 3IMGC450 GOOSENECK MICROPHONE INSTRUCTION MANUAL
INSTALLING SHOCK MOUNT & IMGC450 MICROPHONE
Loading...