Australian monitor IC30 DATASHEET

IC30

30W, 3 Channel Mixer Amplifier

Description

The IC30 is a 3 channel, 30 watt mixer amplifier designed for both AC and 12 volt DC opera-

tion. The amplifier is a self contained compact unit of solid steel construction suitable for table

or desk mounting. An optional rack mount kit is also available.

Inputs

The IC30 has three universal inputs, each with separate level controls. Each channel will accept

balanced or unbalanced microphone or a line/auxiliary input. The unit has industry standard

XLR microphone sockets and a single RCA socket for each channel.

Outputs

The IC30 features 100 volt, 70 volt & 4 ohm isolated transformer outputs. A tape recorder out-

put by means of an RCA is also provided.

Tone Generator

The IC30 will accept the ATC5488, an optional, plug-in four tone generator module. The

ATC5488 connects to a 7 pin receptacle inside the amplifier and provides Bell, Pre-announce

Chime, Alert Tone (AS2220.1) and Evacuate Tone (AS2220.1). Any of these tones can be acti-

vated from a simple contact closure which may be wired to the spare terminals on the rear of

the amplifier.

Muting

The IC30 includes a muting facility where channels 2 and 3 are muted when two terminals on

the rear panel of the amplifier are shorted. Alternatively, an optional plug-in VOX muting card

(TX3010) is available. With the TX3010 installed, signal on input 1 will automatically mute

inputs 2 and 3.

Protection

Internal current limiting protects the amplifier from overload and overdrive conditions.

Australian Monitor Installation Series amplifiers feature a protection network that provides

greater stability and performance. Our amplifiers are recognised

worldwide for their reliability and this is due to the extensive levels of

current limiting which protect the amplifiers from both overload and

overdrive conditions.

Power Output 30 Watts RMS

Maximum Load 330 Ohms @ 100 Volts

Frequency Response 70Hz - 15kHz (± 3dB)

Total Harmonic Distortion 0.3% @ 1 kHz rated power @ 70 Volts

Signal To Noise Ratio -68dB with all controls at their centre position

Tone Controls Bass @ 100Hz: Boost +12dB, Cut -12dB; Treble @ 10kHz: Boost +9dB, Cut -9dB

Inputs Three mic/aux universal inputs with XLR female mic sockets and RCA aux sockets

Input Sensitivity Mic: 1.5mV @ 200 Ohms; Aux: 75mV @ 47K Ohms

Outputs Speaker: 100, 70 Volts, 4 Ohms; Tape: 400mV @ 10K Ohms

Controls 3 Input channel gain controls, 1 Bass control, 1 Treble control

Metering/Indicators Power ”on“ LED

Power Sources AC: 230/240V - 50Hz, 110V - 60Hz (special) 3 pin IEC connector; DC: 12 Volts

Power Consumption 60 Watts (maximum)

Protection Overdrive protection

Dimensions/Weight 76mm H x 303mm W x 180mm D (Chassis dimensions only). 8kg

Rack Mounting Optional IC30RMK rack mount kit

Tone Generator Optional four tone module ATC5488

Muting Shorting muting facility included or optional VOX muting module TX3010

ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

The mixer amplifier shall have three universal inputs each comprising of a balanced microphone with

XLR female sockets and auxiliary input using single RCA sockets.

The amplifier master section shall include three channel level controls, two EQ controls, one with 12dB

of cut and boost at 100Hz and the other with 9dB of cut and boost at 10kHz. Speaker outputs shall be

transformer isolated at 100 volt, 70 volt & 4 ohms. The amplifier must be capable of delivering 30 watts

RMS into a 330 inductive ohm load, with less no more than 0.3% distortion measured at 1kHz @ 70 volts

and with system hum and noise at less than -68dB. The amplifier shall be capable of operating on mains

power and 12V DC.

The amplifier shall be an Australian Monitor Installation Series model IC30.

Engineered and Distributed By AUDIO TELEX COMMUNICATIONS PTY LTD (ABN 78 001 345 482), 149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia

NSW Tel: [phone] Fax: [phone] VIC Tel: [phone] Fax: [phone] QLD Tel: [phone] Fax: [phone] WA Tel: [phone] Fax: [phone]

TAS Tel: [phone] Fax: [phone] SA Tel: [phone] Fax: [phone] Export Enquiries: [e-mail]

Website: www.australianmonitor.com.au