Australian monitor AV25PS, AV40PS User Manual

ACTIVE TWO WAY STEREO SPEAKER SYSTEMS

INSTALLATION AND OPERATION MANUAL

TREB

INPUT

OUTPUT

AV25PS/AV40PS

1. Save the carton and packing material even if the equipment has
arrived in good condition. Should you ever need to ship the unit,
use only the original factory packing.

2. Read all documentation before operating your equipment.
Retain all documentation for future reference.

3. Follow all instructions printed on unit chassis for proper operation.

4. Do not spill water or other liquids into or on the unit, or operate the
unit while standing in liquid.

5. Make sure power outlets conform to the power requirements listed
on the back of the unit.

6. Do not use the unit if the electrical power cord is frayed or broken.
The power supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them,
paying particular attention to cords and plugs, convenience
receptacles, and the point where they exit from the appliance.

7. Always operate the unit with the AC ground wire connected to the
electrical system ground. Precautions should be taken so that the
means of grounding of a piece of equipment is not defeated.

8. Mains voltage must be correct and the same as that printed on the
rear of the unit. Damage caused by connection to improper AC

voltage is not covered by any warranty.

9. Have gain controls on amplifiers turned down during power-up to
prevent speaker damage if there are high signal levels at the inputs.

10. Power down & disconnect units from mains voltage before making
connections.

11. Never hold a power switch in the “ON” position if it won’t stay
there itself!

12. Do not use the unit near stoves, heat registers, radiators, or other
heat producing devices

13. Do not block fan intake or exhaust ports. Do not operate equipment
on a surface or in an environment which may impede the normal
flow of air around the unit, such as a bed, rug, weathersheet, carpet,
or completely enclosed rack. If the unit is used in an extremely dusty
or smoky environment, the unit should be periodically “blown free”
of foreign matter.

14. Do not remove the cover. Removing the cover will expose you to
potentially dangerous voltages. There are no user serviceable
parts inside.

15. Do not drive the inputs with a signal level greater than that required
to drive equipment to full output.

16. Do not connect the inputs / outputs of amplifiers or consoles to
any other voltage source, such as a battery, mains source, or
power supply, regardless of whether the amplifier or console is
turned on or off.

17. Do not run the output of any amplifier channel back into another
channel’s input. Do not parallel- or series-connect an amplifier
output with any other amplifier output.

Australian Monitor Inc is not responsible for damage to
loudspeakers for any reason.

18. Do not ground any red (“hot”) terminal. Never connect a “hot”
(red) output to ground or to another “hot” (red) output!

19. Non-use periods. The power cord of equipment should be unplugged
from the outlet when left unused for a long period of time.

20. Service Information Equipment should be serviced by qualified
service personnel when:

A.The power supply cord or the plug has been damaged.
B.Objects have fallen, or liquid has been spilled into the equipment
C. The equipment has been exposed to rain
D.The equipment does not appear to operate normally,

or exhibits a marked change in performance

E. The equipment has been dropped, or the enclosure damaged.

IMPORTANT SAFETY INFORMATION

This symbol is intended to alert the user to the presence
of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence
of important operation and maintenance (servicing)
instructions in the literature accompanying the appliance.

To prevent electric shock do not use this (polarised) plug
with an extension cord, receptacle or other outlet unless
the blades can be fully inserted to prevent blade exposure.
To prevent electric shock, match wide blade of plug to
wide slot, fully insert.

Caution:

AUS, EUR, USA

Copyright 1st Mar 2005

Rev A: 1st Mar 2005

The AMAV AV25PS & AV40PS are active two way stereo speaker
systems.

The AV25/40PS each consist of one powered & one passive speaker.
Both are of a compact & architecturally pleasing design & feature an
onboard stereo amplifier, treble, bass & volume control, power switch,
stereo RCA line input, speaker output & installation brackets.

The AV25PS features a 5" bass driver & dome tweeter & delivers
25 watts RMS while the AV40PS features a 6.5" bass driver & dome
tweeter & delivers 40 watts RMS.

The new AMAV AV powered speakers deliver high quality sound
reinforcement for a variety of Audio Visual applications. Compact
& well designed, they are easy to operate & will become a standard
in many AV installations.

INTRODUCTION 3

REAR PANEL 4

SPECIFICATIONS 5

INTRODUCTION AND CONTENTS