AUO T315HW01 V0 Specification
Global LCD Panel Exchange Center
www.panelook.com
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
1/27
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Document Version : 0.3
Date : 2008/5/28
Product Specifications
31.5” WXGA Color TFT-LCD Module
Model Name: T315HW01 V0
() Preliminary Specifications
(*) Final Specifications
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
2/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
No
COVER
CONTENTS
RECORD OF REVISIONS
1 GENERAL DESCRIPTION
2 ABSOLUTE MAXIMUM RATINGS
3 ELECTRICAL SPECIFICATIONS
4 BACKLIGHT CONNECTOR PIN CONFIGURATIO
5 OPTICAL SPECIFICATIONS
6 MECHANICAL CHARACTERISTICS
www.panelook.com
Contents
7 RELIABLITY
8 INTERNATIONAL STANDARDS
9 PACKING
10 PRECAUTIONS
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
3/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Record of Revision
Version Date No Old Description New Description Remark
0 2007/12/26 First issue
0.1 2008/03/20 1 Display area: 696.96 (H) x 392.04 (V) Display area: 698.4 (H) x 392.85 (V)
3-2 LVDS Option: Low/Open, NS mode
LVDS Option: H(3.3V), JEIDA mode
4-1 Electrical specification
5 Contrast Ratio : 3000 Contrast Ration : 2500
9 Update label format Update label format
0.2 2008/04/25 Final
0.3 2008/5/28 No Appendix Appendix: Add dimming information Update
LVDS Option: High/Open, NS mode
LVDS Option: Low (0V), JEIDA mode
version
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
4/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
1. General Description
This specification applies to the 31.5 inch Color TFT-LCD Module T315HW01 V0. This LCD
module has a TFT active matrix type liquid crystal panel 1920x1080 pixels, and diagonal size of
31.5 inch. This module supports 1920x1080 HDTV mode (Non-interlace).
Each pixel is divided into Red, Green and Blue sub-pixels or dots which are arranged in vertical
stripes. Gray scale or the brightness of the sub-pixel color is determined with a 8-bit gray scale
signal for each dot.
The T315HW01 V0 has been designed to apply the 8-bit 1 channel LVDS interface method. It is
intended to support displays where high brightness, wide viewing angle, high color saturation, and
high color depth are very important.
The T315HW01 V0 model is RoHS verified which can be distinguished on panel label.
*
General Information
Items Specification Unit Note
Active Screen Size 31.51 inches
Display Area 698.4 (H) x 392.85 (V) mm
Outline Dimension 760.0(H) x 450.0(V) x 45(D) mm With inverter
Driver Element a-Si TFT active matrix
Display Colors 16.7M Colors
Number of Pixels 1920x1080 Pixel
Pixel Pitch 0.36375 mm
Pixel Arrangement RGB vertical stripe
Display Mode Normally Black
Surface Treatment AG, 3H Haze = 11
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
5/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
2. Absolute Maximum Ratings
The following are maximum values which, if exceeded, may cause permanent damage to the unit.
Item Symbol Min Max Unit Conditions
Logic/LCD Drive Voltage Vcc -0.3 14 [Volt] Note 1
Input Voltage of Signal Vin -0.3 3.6 [Volt] Note 1
BLU Input Voltage VDDB -0.3 28 [Volt] Note 1
BLU Brightness Control Voltage Vdim -0.3 7.0 [Volt] Note 1
Operating Temperature TOP 0 +50 [oC] Note 2
Operating Humidity HOP 10 90 [%RH] Note 2
Storage Temperature TST -20 +60 [oC] Note 2
Storage Humidity HST 10 90 [%RH] Note 2
Panel Surface Temperature PST 65 [oC]
Note 1: Duration:50 msec.
Note 2 : Maximum Wet-Bulb should be 39 and No condensation.
The relative humidity must not exceed 90% non-condensing at temperatures of 40 or less. At temperatures great
than 40 , the wet bulb temperature must not exceed 39 .
кк
к
к
er
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
6/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
D
www.panelook.com
3. Electrical Specification
The T315HW01 V0 requires two power inputs. One is employed to power the LCD electronics and to drive the TFT
array and liquid crystal. The second input power for the BLU, is to power inverter..
3-1 Electrical Characteristics
Values Parameter
Unit Notes
Min Typ Max
LCD:
Power Supply Input Voltage Vcc 10.8 12 13.2 Vdc 1
Power Supply Input Current Icc - 0.55 0.65 A 2
Power Consumption Pc - 6.6
Inrush Current I
LV DS
Interface
ifferential Input High Threshold
Vo l t a g e
Differential Input Low Threshold
Vo l t a g e
Common Input Voltage
- - 6 Apeak 3
RUSH
VTH 100 mV 4
VTL 100 mV 4
VCIM 1.10 1.25 1.40 V 4
7.5 Watt 2
CMOS
Interface
Input High Threshold Voltage
Input Low Threshold Voltage
VIH
2.4 3.3 Vdc
(High)
VIL
0 0.7 Vdc
(Low)
Backlight Power Consumption PDDB 110 115 120 Watt
Life Time 50,000 Hours 6
Note :
1. The ripple voltage should be controlled under 10% of V
=
f
2. Vcc=12.0V,
60Hz, fCLK=81.5Mhz , 25 , Test Pattern : White Patternк
v
3. Measurement condition :
ˌ˃ʸ
GND
˄˃ʸ
˧˻ʳːʳˇˊ˃ʳ˦
CC
VCC
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
7/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
4. VCIM = 1.2V
www.panelook.com
VCIM
0V
5. Do not attach a conducting tape to lamp connecting wire. If the lamp wire attach to conducting tape, TFT-LCD
Module have a low luminance and the inverter has abnormal action because leakage current occurs between
lamp wire and conducting tape.
6. The relative humidity must not exceed 80% non-condensing at temperatures of 40 or less. At temperatures
greater than 40 , the wet bulb temperature must not exceed 39 . When operate at low temperatures, the
brightness of CCFL will drop and the life time of CCFL will be reduced.
кк
VTH
VIL
к
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
8/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
3-2 Interface Connections
- Connector on Panel: JAE FI-RE51S-HF (Manufactured by JAE)
-
www.panelook.com
Note:
1. All GND (ground) pins should be connected together and should also be connected to the LCD’s metal frame.
All Vcc (power input) pins should be connected together.
2. For Pin 10, 27 and 28, panel will not damage if negligently connect these pins to high or low
Ϩ
Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved. T315HW01 V0 - Spec. Ver 0.3
9/28
No Reproduction and Redistribution Allowed
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Loading...