Audiovox VOD705 User Manual

P .

®

ELECTRONICS COR

VOD705 DL Drop Down DVD Video Monitor

OPEN

Installation Guide

For Custom er Service

Visit Our Website At

.audiovox.com

999

Product Information, Photos,

FAQ’s Owner ’s Manuals

Important Notice

It is unlawful in most jurisdictions for a person to
drive a motor vehicle which is equipped with
a television viewer or screen that is located
in the motor vehicle at any point forward of
the back of the driver's seat, or that is visible
directly or indirectly to the operator of the
motor vehicle.

MATERIALS INCLUDED IN THIS PACKAGE:

3c

1) VOD705 DL DVD Video Monitor (P/N 136D2136) (1 pc)

2) Accessory 8 pin FM Transmitter Harness with Transformer (P/N 112B3106) (1 pc)

3) 18 Pin Power / Signal Harness with Two DIN Connectors and Cable Clamps (P/N 1123107) (1 pc)

4) 2 Pin Power Wire Harness with Choke (P/N 112B3143) (1 pc)

5) Hardware Package (P/N 150-1427)
#6 x 1/4” Screws (11 pcs)
#8 x 5/8” Self Drilling Screws (5 pcs)
#8 Washers (5 pcs)
Rubber Plug (1pcs)

6) Remote Control (P/N 136C2127) (1pc)

7) Protective Covers (2pcs)

Left Protective Cover for IR sensor (P/N 102B3687) (1pc)
Right Protective Cover for Headphone Jacks (P/N 102B3688) (1pc)

8) FM Modulator (P/N 136C2152) (1pc)

9) Dome Light Harness (P/N 112B3110) (1pc)

1

OPEN

6

DVD

EJECT

POWER

SURROUND

EQ

DISPLAY

ANGLE

AUDIO

MUTE

Enter

SETUP

MENU

REPEAT

RETURN

A-B

7

2

4

5

Cable Clamps

3

located here.

3e

8

9

TOOLS REQUIRED:

#2 Phillips Screwdriver
#1 Phillips Screwdriver
Utility or Razor Knife or Shears
Wire Strippers
Upholstery Hook Tool (for removal of panels as necessary)
Electrical T ape
Masking T ape
Multimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)
Marker (to mark headliner)
Scribe (to mark trim ring if used)
Misc. Electrical Connectors (to connect to vehicle power source). Requirements will vary from vehicle to vehicle)
DVD (to verify system operation after installation)

-1-

GENERAL INSTALLATION APPROACH:

1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP,
Tuner , RF Modulator/external amp, remote headphones, 2

2) Review all manuals to become familiar with electrical requirements and hook ups.

3) Decide upon mounting locations of all components and method of mounting.

4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as
all areas where interconnecting wire harnesses will need to be located. If any access holes need to
be cut into the vehicle (headliner, other trim components etc.), this should be done now as well.
(Refer to Page 3).

5) Route the wiring harnesses throughout the vehicle as necessary. (Refer to the Wiring Diagrams on
pages 6 of this manual as well as the wiring instructions for the individual components and accessory
options being installed). Be sure that all wiring is protected from sharp edges and is routed in such a
manner that it will not be pinched when all components and interior trim are fully installed. Be sure to
leave enough slack in the wiring at each component to allow working room.

6) Remove all A/V system components from their packaging and place them loosely in the vehicle at
their respective locations.

7) Connect all components together (electrically) and verify proper operation of all system functions.
Note: This is best done BEFORE, components have been permanently mounted.

8) After verifying proper operation of the system, proceed to mount each component.

9) When all components are mounted, recheck function of entire system again to ensure that no wiring
was pinched or connected improperly during final installation.

nd

VCP, etc.).

GENERAL SYSTEM CONFIGURATIONS:

The following is intended to provide some of the system configurations that are possible with the VOD705 DL
Drop Down Video Systems:

System 1: Video Monitor (VOD705 DL), with VCP .

Optional Accessory Harness (PN 8010730) must be purchased.

System 2: Video Monitor (VOD705 DL), VCP, Second VCP (or other A/V component)

-Same as system 1 but 2 extra Source Components. Optional Accessory
Harnesses (PN 8010730) must be purchased.

Notes:

The VOD705 DL video systems are only intended for an overhead, drop down installation.
It is not intended for seat back or any other type of mounting. The hinging mechanism
is designed for horizontal, drop down use only.

-2-