Audiovox VOD1023, VOD1023 S User Manual

VOD1023 /

VOD705

VOD1023 S /

VOD1023 P

SOURCE

ELECTRONICS CORP .

DVD PLA YER

WITH

DROP-DOWN

VIDEO

MONITOR

128-7255A

1 of 37

Important Notice

An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle’s parking brake is applied.

An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver’s seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle.

Warnings

Do not use any solvents or cleaning materials when cleaning the video monitor. Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened lint free cloth to wipe the screen if it is dirty. Lock the LCD screen in the fully closed position when not in use. Before putting on headphones always adjust the volume setting to the lowest position. Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain the vehicle’s battery. Do not put pressure on the screen. Caution children to avoid touching or scratching the screen, as it may become dirty or damaged.

Television Reception

This entertainment system is designed primarily for viewing prerecorded movies or playing video games. Television reception in a moving vehicle will be limited and in some areas will not be possible due to weak and variable signal strength. Television viewing in a stationary vehicle will result in an improvement, but may still be marginal due to signal strength. The quality of the picture will not be consistent with home TV reception. Reception may be affected by weather and distance from TV station. A weak signal may cause the picture to roll, be snowy, or cause some color loss.

Licensed under one or more of the following patents, Patent NOS. 5,775,762 and 5,927,784

128-7255A

2 of 37

Congratulations on your purchase of the Audiovox VOD1023 DVD Player with Drop-Down Video /Monitor. The VOD1023 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product to ensure that you obtain the best results from your equipment. Please note: Installation options vary , see the individual owner’s manuals for each component in your system to obtain a full

understanding of each component’s operation.

Safety Precaution

For safety reasons, when changing video media it is recommended that the vehicle is not in motion, and that you do not allow children to unfasten seat-belts to change video media or make any adjustments to the system. System adjustments can be accomplished using the remote control, while seatbelts remain fastened. Enjoy your Audiovox entertainment system but remember the safety of all passengers remains the

number one priority.

Features

••

• 10.2 Inch TFT (Thin Film Transistor) Active Matrix LCD

••

(Liquid Crystal Display) Monitor

••

• On Screen Display

••

• Optional TV Tuner*

••

• Full Function Remote Control

••

• Infrared Transmitter for IR W ireless Headphones.

••

• T wo Audio / Video Inputs (AV1/AUX)

••

• Built-in DVD Player

••

• T wo Headphone Jacks

••

• Built-in Five Frequency Wireless FM Modulator

••

(**Optional Relay Box)

••

• A V Line Out

••

• Forward and Side Remote Sensor

••

• Dome Lights with Switch

••

• Backlit Controls for Low Light Operation

••

• Last Position Memory for DVD

••

• Game Port

••

Options * Audiovox P/N PODTVT

** Audiovox P/N SIRSWB

128-7255A

3 of 37

Controls and Indicators Diagram

10 11

12 13

14 22

2 3

SOURCE

4 5

21 18

19 20

17 16

128-7255A

4 of 37

Control Function Descriptions

1. Disc insertion slot – For loading Disc.

2. POWER Button – Used to turn the system ON/OFF . Bright

red when system is on, dim when off.

3. EJECT ( ) Button – For ejecting discs from the disc compartment.

4. PLA Y ( ) Button – This button is used to start playback of a disc.

5. STOP ( ) Button – To stop playback.

6. Infrared Transmitter and Sensor – Use to transmit audio

to the wireless headphones. Also allows the remote control to operate the VOD1023 and to control other accessories in the system.

7. VOD1023 Ventilation Opening.

8. Dome Lights – Provide additional interior illumination.

9. SOURCE Select – Used to select one of the three sources

(DVD, A V1, AUX/GAME, *TV Optional).

10. ( – ) Button – Used to decrease levels in the picture adjustment mode.

12. ( + ) Button – Used to increase levels in the picture adjust mode.

13. Side Remote Sensor Eye – Allows the remote control to operate the VOD1023, control volume to wired headphone jacks and control the other accessories.

14. AUX Input (use with supplied A V adaptor)

••

• Auxiliary Audio Right Input.

••

• Auxiliary Audio Left Input.

••

• Auxiliary Video Input.

••

15. Drop Down LCD Panel.

16. Headphone Jacks – Allow the use of wired headphones

with a 1/8” plug for listening to the video program audio.

17. Screen release – Moves in direction of the arrow to release the drop down screen.

18. VOLUME ( ) Button – Use this button to raise the volume level of the headphone jacks.

* Consult the PODTVT Installation/Owner’s Manual for optional TV tuner instructions.

1 1. PICTURE SELECT Button – Allows the user enter the

picture adjustment mode.

128-7255A

5 of 37

19. FM Select Button – When this button is pressed it will turn on the wireless FM Modulator and then cycle through the available FM frequencies (Channel 1, 88.3MHz; Channel 2, 88.7MHz; Channel 3, 89.1MHz; Channel 4, 89.5MHz; Channel 5, 89.9MHz and OFF).

20. VOLUME ( ) Button – Use this button to decrease the volume level of the headphone jacks.

Note:These buttons will not affect the volume of wireless

headphones or the wireless FM modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio’s volume control (see page 16, Wireless Headphones, or page 17, Wireless FM Modulator).

21. Three position Dome Light Switch

• Auto – Automatically switches on the dome lights in

conjunction with the vehicle’s interior illumination.

• Off – The dome lights will not turn on in this position.

• On – Turns on the dome lights.

22. Game Port – Connect the supplied game controller to this input to play a variety of video games.

Note: When using the Game Controller, the AUX input must

be removed.

Note : Audiovox recommends the use of the Audiovox HP275

Headphones when using wired headphones.

128-7255A

6 of 37

Remote Control Operation

BATTERY COVER

Battery Installation

Before attempting to operate your Remote Control, install the batteries as described below .

1)Turn the Remote Control face down. Using a fingernail, lift the battery cover off.

2)Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed.

3)Align the cover tabs with the remote control and press down until the cover clicks.

The remote control will operate the VOD1023 and most Audiovox VCP’s. It is not a universal remote control and will not control equipment from other manufacturers.

1 2

3 4 5

6 7

9 10 11

12 13 14 15 16 17 18 19 20 21

146) 146*

42 41 40

39 38

37 36

35 34 33 32 31 30 29 28 27 26 25 24

23 22

128-7255A

7 of 37

Remote Control Function Descriptions

* Function control is available on the unit and the remote control. ** Not used in this model

*** The TV Option will only be displayed and the TV control functions are only available if the optional TV Tuner (P/N PODTVT) is

installed.

1. POWER Button*

Press this button to turn the VOD1023 on. Press the button again to turn the VOD1023 off.

2. SOURCE Button*

Each time the button is pressed, the audio / video source will change: DVD, A V1, AUX/GAME and TV***.

3. AUTO MEMORY Button (AUTO PROGRAM Button)***

When the AUTO MEMORY button is pressed, all channels are searched and channels that are detected with signals of sufficent levels are automatically stored.

4. SKIP/SEARCH Button***

This button selects betweeen SKIP and SEARCH mode. In “SKIP mode” the TV tuner will tune and stop on channels that are programmed into memory when the CHANNEL UP/DOWN buttons are used. When the SKIP mode is disabled, the TV will stop on all active channels.

5. ERASE/WRITE Button***

While tuned to a channel, pressing this button will store or erase the channel from memory . The stored channel numbers are displayed in “GREEN” and the erased channel numbers are displayed in “RED”.

6. Channel Up ( ) Button

Use this button to increase the channel number*** to the desired channel and to scroll upward in menu options.

128-7255A

8 of 37

7. MUTE Button

Press this button to mute the audio. Pressing the button again restores the sound to the previously set level.

8. ENTER Button

Used to implement a selected setting or menu option.

9. LEFT ( ) Button

Allows the user to shift left in the menu options.

10. MENU Button

Allows the user to access the DVD (DVD MODE) main menu and monitor menu (TV MODE).

11 . RETURN Button**

12. TV Mode Select Button***

Switches certain function keys on the remote control for TV functions.

13. DVD Mode Select button

Switches certain function keys on the remote control for DVD functions.

128-7255A

9 of 37

14. DISPLA Y Button

Press to display DVD Disc current information. Press DISPLA Y button DVD Player Perform Once Display current TITLE , CHAPTER & elapsed time

Twice Display current SUBTITLE 3 times Display current AUDIO language & channel

4 times Display current surround mode

5 times Display current ANGLE 6 times Display A-B repeat status 7 times Display REPEAT status 8 times Display off

For Subtitle, Audio, Surround, Angle, A - B & Repeat, press Enter key repeatedly to change the options. These options may vary from disc to disc.

15. FM TRANSMITTER ON/OFF Button

Turns the wireless FM Modulator power on/off.

16. AUDIO Button

Press this button to display and select the desired AUDIO language. Each time the button is pressed, the language or track changes.

NOTE: The languages & tracks you can select are vary from disc to disc.

128-7255A

10 of 37

17. ZOOM Button – Press this button to zoom the picture Press ZOOM button OSD DVD Player Perform Once 2 X ZOOM picture 2 times

Twice 3 X ZOOM picture 3 times 3 times 4 X ZOOM picture 4 times 4 times 1/2 Reduces picture to 1/2 normal size

5 times 1/3 Reduces picture to 1/3 normal size 6 times 1/4 Reduces picture to 1/4 normal size 7 times OFF Returns to normal size

18. P AUSE ( ) Button

Allows the user to pause the playback. Pressing the Pause button again or the Play button will resume playback.

19. STOP (n) Button*

Disc playback will be stopped.

20. PREVIOUS ( ) Button

Allows the user to return to the previous chapter or track.

21. NEXT ( ) Button

Allows the user to skip to the next chapter or track.

22. REV ( ) Button

Allows the user to search in a backward direction at 2, 4, 8, 16 and 32 times the normal speed.

128-7255A

11 of 37

23. FWD ( ) Button

Allows the user to search in a forward direction at 2,4,8, 16 and 32 times the normal speed.

24. PLAY ( )Button*

Press this button to activate the play mode when a disc is loaded into the disc compartment.

25. ANGLE Button

Press this button to display and select from the available camera angles. Each time this button is pressed, the angle will change.

NOTE: The number of angles vary from disc to disc.

26. SUBTITLE Button

Press this button to display and select the available subtitle language in DVD. Each time the button is pressed, the subtitle language changes.

27. SOURCE SELECT Button**

With FM ON, used to select the Audio source to the FM Modulator, POD audio or SAT Audio (Second IR input). With FM OFF, used to select from SAT Audio or Car Audio.

28. CHANNEL SELECT Button* (FM Select)

Selects the wireless FM modulator Frequency (Frequency 1, 88.3MHz, Frequency 2, 88.7MHz, Frequency 3, 89.1MHz, Frequency 4, 89.5MHz, Frequency 5, 89.9MHz).

NOTE: The type & number of languages for subtitles vary from disc to disc.

29. VCP Mode Select button

Switches certain function keys on the remote control for VCP functions.

30. Screen Mode Button

Allows the user to change screen format ( Aspect Ratio, 4:3 or 16:9 )

128-7255A

12 of 37

+ 25 hidden pages