Audiovox VM9115 Installation Manual

VM9115

Installation Guide

What’s in the Box

VM9115 Head Unit

Single DIN Sleeve

Wiring Harness

Parking Brake Wire

Mounting Hardware

Cosmetic Trim Ring

Owner’s Manual

Installation Guide

Tools and Supplies

You will need these tools and supplies to install your VM9115:

• Torx type, at-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING! Never install this unit where operation and viewing could interfere
with safe driving conditions.

VM9115

Disconnecting the Battery

To prevent a short circuit, be sure to turn o the ignition and remove the negative (-) battery cable prior to installation.

NOTE: If the VM9115 is to be installed in a car equipped with an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use
extra caution during installation to avoid causing a short circuit.

Pre-installation

1. Remove the four screws that attach the mounting sleeve to the
radio and remove the sleeve.

2. Install the mounting sleeve:
a. Install mounting sleeve into the dashboard or optional adapter.
Do not force the sleeve into the opening or cause it to bend
or bow.
b. Locate the series of bend-tabs along the top, bottom and sides
of the mounting sleeve. With the sleeve fully inserted into the
dashboard opening, bend as many of the tabs outward as
necessary so that the sleeve is rmly secured to the dashboard.
c. Install the support strap to make the unit more stable.

3. Place the radio in front of the dashboard opening so the wiring can
be brought through the mounting sleeve.

EJ

ECT

A

/
V

INPU

T

CAUTION! Be careful not to damage the car wiring.

2b

2c

2a

TAB

TAB

DASHBOARD

DASHBOARD

2