The following marks and symbols are located on
back of the unit.
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION:
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT OF WALL OUTLET,
THEN FULLY INSERT.
The lightning flash with an arrowhead
symbol, within the equilateral triangle, is
intended to alert the user to the presence
of uninsulated "dangerous voltage" within
the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within the
equilateral triangle is intended to alert the
user to the presence of important operating
and maintenance (servicing) instructions
in this owner’s manual.
Caution marking is located on back enclosure of the unit.
CAUTION
INVISIBLE LASER RADIATION IS
EMITTED WHEN OPENED AND
INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a
low power laser device.
The symbol for Class
(Double lnsulation)
On Placement
• Do not use the unit in places which are extremely hot, cold, dusty, or humid.
• Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth,
or by placing it on carpeting.
On Safety
• When connecting or disconnecting the AC power cord, grip the plug and not the cord itself. Pulling the
cord may damage it and create a hazard.
On Condensation
• When left in a heated room where it is warm and damp, water droplets or condensation may form inside
the unit. When there is condensation inside the unit, the unit may not function normally. Let the unit stand
for 1 to 2 hours before turning the power on, or gradually heat the room and allow the unit to dry before
use.
- 1 -
SAFETY PRECAUTIONS
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Shielded cables must be used with this unit to ensure compliance with the Class FCC limits.
WARNING: Should any trouble occur, disconnect the AC power cord and refer servicing to a
qualified technician.
Notes on Copyright
It is forbidden by law to copy, broadcast, show, broadcast on cable, play in public, or rent copyrighted material
without permission.
Apparatus Claims of "U.S. Patent Nos. 4,907,093; 5,315,448; and 6,516,132." licensed for limited viewing uses
only.
This product incorporates copyright protection technology that is protected by U.S. patents and other
intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision,
and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision.
Reverse engineering or disassembly is prohibited.
- 2 -
IMPORTANT SAFETY INSTRUCTIONS
1.Read these instructions.
2.Keep these instructions.
3.Heed all warnings.
4.Follow all instructions.
5.Do not use this apparatus near water.
6.Clean only with a dry cloth.
7.Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions.
8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. When the provided plug does
not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience recep-
tacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manu-
facturer, or sold with the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as the power-supply cord or plug is damaged, liquid has spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
Region Management Information: This unit is designed and manufactured to respond to the Region
Management Information that is encoded on DVDs. If the region number printed on the DVD does not
correspond to the region number of this unit, this unit cannot play that disc.
The region number of this unit is 1.
Disc Function or Operation that is Not Available
When the “ ” symbol appears on the screen, it indicates that the function or operation attempted is not
available at that time. This occurs because the DVD manufacturer determines the specific functions. Certain
functions may not be available on some discs. Be sure to read the documentation provided with the DVD.
Compatible
Icons Used on DVDs
Sample lcons
Note:
• When playing a CD-G (Graphics) or CD EXTRA disc, the audio portion will be played, but the graphic
images will not be shown.
Language selections for audio
Language selections for subtitles
Screen aspect ratio
Multiple camera angles
Region code indicator
Titles, Chapters and Tracks
• DVDs are divided into “titles” and “chapters”. If the disc
has more than one movie on it, each movie would be a
separate “title”. “Chapters” are sections of titles.
• Audio CDs are divided into “tracks”. A “track” is usually
one song on an Audio CD.
Note :
Numbers identify each title, chapter, and track on a disc. Most discs have these numbers recorded
on them, but some do not.
Notes on Unauthorized Discs
You may not be able to play back some DVDs on this unit if they were purchased from outside your
geographic area or made for business purposes.
- 5 -
ACCESSORIES
Please Check and Identify the Included Accessories.
Remote control ............................................................................................................................. x 1
AAA 1.5V battery .......................................................................................................................... x 2
Mounting template ......................................................................................................................... x 1
1.06" (27mm) spacers .................................................................................................................. x 4
.57" (14.4mm) spacers ................................................................................................................. x 4
.32" (8.2mm) spacers ................................................................................................................... x 4
#M 5 x 69 mm screws .................................................................................................................... x 4
#M 5 x 40 mm screws ................................................................................................................... x 4
Warranty Card .............................................................................................................................. x 1
Registration Card .......................................................................................................................... x 1
REMOTE CONTROL
Using the Remote Control
• This remote control is magnetic and can be attached to most refrigerators. Some refrigerators panels
are not metallic. In this case, try attaching the magnetic remote control to the side of the refrigerator.
• Point the remote control at the REMOTE SENSOR located on the unit.
• When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may
be degraded, causing unreliable operation.
• The recommended effective distance for remote operation is about 16 feet (5 meters).
T o Install Batteries
1. Open the battery door.2. Insert two AAA batteries.
Battery Replacement
When the batteries become weak, the operating distance of the remote control is greatly reduced and you
will need to replace them.
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
Notes:
• Do not place the remote control near magnetic devices or magnetic cards.
• If the remote control is not going to be used for a long time, remove the batteries to avoid corrosion
damage caused by battery leakage.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
• Always remove batteries as soon as they become weak.
• Weak batteries can leak and severely damage the remote control.
• WARNING: Do not dispose of batter ies in a fire. Batteries may explode or leak.
- 6 -
Remote Control
1
2
3
4
5
6
7
8
9
10
11
12
CONTROL REFERENCE GUIDE
1)
FUNCTION Button
Use to select DVD, TV or RADIO mode.
2)
PICTURE
123
789
0
EXIT
RETURN
DVD MENU
STOP
BAND
FORMAT
MTS
TV MENU
654
LAST CH
MUTE
SOUND
PICTURE Button
Selects from preset screen display
settings to match the type of show you
are watching.
3)
MEMORY Button
Sets title/chapter in a favorite order.
Enter the number of a selected station.
4)
EXIT/RETURN Button
Press to exit the TV menu and return
directly to normal viewing.
5)
DVD MENU Button
Press to enter the main menu of the
DVD you are watching.
6)
VOLUME (+/-) Buttons
Adjusts the volume.
7)
/
TUNING Buttons
: Fast reverse playback.
: Fast forward playback.
TUNING
radio stations.
8)
PREV Button
Selects previous titles, chapters or
tracks on a disc.
9)
ANGLE Button
During DVD playback, switch the
camera angle of the video presentation
when scenes with multiple camera
angles are recorded on a DVD.
10)
GOTO Button
Goes directly to a location on a DVD/
CD.
11)
AUDIO Button
Selects audio soundtracks of a DVD or
change the output mode of a CD.
MTS Button
Press to select MONO sound,
STEREO sound or Secondary Audio
Program (SAP).
FORMAT Button
12)
Press to select the picture format.
: Scans all available
- 7 -
Remote Control
PICTURE
123
789
EXIT
RETURN
DVD MENU
STOP
BAND
FORMAT
MTS
CONTROL REFERENCE GUIDE
13)
STANDBY/ON Button
Tur ns on the unit and puts it in standby
mode.
14)
Number (0-9) Buttons
15)
LAST CH Button
Press to switch repeatedly between the
13
654
14
LAST CH
0
TV MENU
15
16
17
MUTE
18
19
20
SOUND
21
22
23
24
last two channels displayed.
16)
TV MENU Button
Press to display the on-screen TV
menu.
17)
CURSOR (
,
Use to highlight selections on a screen
and make adjustments to certain
settings.
CH+ /
CH- buttons
Use to change TV channels.
ENTER Button
Confirm selections on a menu screen.
MUTE Button
18)
Press to turn off the sound.
STOP/BAND Button
19)
Stops playback.
Switches between AM and FM.
PLAY Button
Starts playback.
PAUSE Button
Pauses playback, frames advance.
20)
NEXT Button
Selects next titles, chapters or tracks
on a disc.
SOUND Button
21)
Press to select from preset sound
settings to match the type of show you
are watching.
SUBTITLE Button
22)
Selects one of the subtitle languages
programmed on a DVD.
SETUP Button
23)
Enters and exits the SETUP menu of
the DVD.
REPEAT Button
Repeats chapter or title of a DVD.
Repeats single track or whole CD.
DISPLAY Button
24)
Changes disc status information
displayed on the screen.
,
) Buttons
,
- 8 -
Unit
CONTROL REFERENCE GUIDE
12
345
812
67
11
10
9
14
13
15
1) Disc Tray
Opens or closes the tray by pressing OPEN/
CLOSE button.
Place a disc on the disc tray, label side up.
2) Display Window
Displays system information.
3) POWER ON Indicators
DVD :DVD indicator
TV :TV indicator
RADIO : RADIO indicator
4) Remote Sensor
Receives the remote control unit signals.
5) POWER Button
Turns the unit on and off.
6) OPEN/CLOSE Button
Use to open/close the disc tray.
7) DVD/TV/RADIO Button
Use to select DVD, TV or RADIO mode.
8) PLAY Button
Press to start or resume playback of a disc.
STOP/BAND Button
Stops playing a disc.
Switches between AM and FM.
ADJUST
Makes adjustments to certain settings.
9) SET CLOCK Button
Use to set the current time.
10) / / CH Buttons
Button
Press to go back to previous chapters/
tracks.
Button
Press to advance to chapters / tracks.
Use to search for a station automatically or
select presetted stations.
CH Buttons
Use to skip/search TV channel.
11) TV MENU Button
Opens and closes the TV menu.
12) VOLUME +/- Buttons
Adjusts the volume levels.
13) TIMER Button
Use to set the cooking timer.
14) ENTER Button
Use to enter the sub-menu and confirm
selections in TV mode.
15) Screen
- 9 -
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.