Audiovox SP11CDP User Manual

DIGITAL AUDIO/COMPACT DISC CHANGER

SP-11CDP

COMPACT

OPENOPEN

DIGITAL AUDIO

Model SP-11CDP
Remotely-Controlled

10-Disc CD Changer

10 DISC AUTO CHANGER

COMPACT DISC AUDIO CHANGER SYSTEM

OO

WNER'SWNER'S

O

WNER'S

OO

WNER'SWNER'S

MAMA

MA

MAMA

NUALNUAL

NUAL

NUALNUAL

HINTS FOR CORRECT AND SAFE
OPERATION

This CD Changer is designed to be operated only on 12 volt
DC negative ground systems. The unit can not be used on
24 volt or positive ground systems.

TEMPERATURE

The unit may not operate correctly in extremely hot or cold
temperatures. It is equipped with a built-in thermal protection
circuit which will stop operation of the unit when the
temperature reaches the pre-set level. If this should
happen, the unit will resume operation when the vehicle
returns to a normal temperature range.

Remove the magazine from the unit when it is not being used
during hot weather. If the discs are left in an extremely hot
car they may warp. If the CD changer is not used for long
periods of time, remove the compact discs from the
magazine, and store them in their cases.

CONDENSATION

Moisture can condense on the laser lens of the CD changer
during rainy and humid days, or right after the heater is turned
on in the car (if the changer is mounted in the passenger
compartment). If this should happen the unit will not operate
correctly. To remedy the situation, remove the discs from the
unit and wait approximately one hour. During this time the
moisture will evaporate and the unit will operate normally.

INTERRUPTIONS IN SOUND (Skipping)

The sound from the unit may "skip" and be interrupted if the
anti-vibration springs are not set correctly, if the changer is
mounted on-end or upside-down, or when travelling on very
rough road surfaces. If this should occur, check for errors
made during installation or wait for the road surface to
improve.

3" (8cm) CD-SINGLES

This unit is not designed to play 3" (8cm) CD-Single discs.
Inserting a 3" disc into the magazine, either with or without a
3" disc adaptor, can damage the changer and the disc. Such
damage will not be covered by the Warranty on this product.

1

HANDLING THE DISCS

Dirt, dust, scratches and warpage cause sound skips during playback and a deterioration of sound quality. To take proper care
of your discs:

COMPACT

1. Use compact discs that have the logo.

2. Fingerprints and dust should be carefully wiped off the disc's signal surface (glossy side) with a soft cloth. Unlike conventional
records, the compact disc has no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should
remove most particles. Wipe in a straight motion from the inside to the outside of the disc. Small dust particles or light stains
will have absolutely no effect on reproduction quality.

3. Never use such chemicals as record sprays, antistatic sprays or fluids, benzine or thinner to clean compact discs. Such
chemicals could irreparably damage the disc's plastic surface.

4. Discs should be put back in their cases after use to avoid serious scratches that could cause the sound to skip.

5. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods of time. Long exposure to
high temperatures can warp the disc.

6. Do not stick paper, labels, or tape on the disc surface.

7. Do not write with any type of pen, pencil, or marker on the disc surface.

8. To minimize fingerprints and smudges on the signal surface, always try to hold the discs by their outer edge and center hole.

DIGITAL AUDIO

2